How To Recycle Newspaper Into Gorgeous Notecards - No Blender Needed!

Maura White
by Maura White
9 Materials
$2
4 Hours
Easy
Here is an easy way on how to recycle newspaper into notecards - and this recipe does not require a blender! This recipe came from this 730 Easy Science Experiments: With Everyday Materials. I had fun showing my daughters how to recycle some newspaper and make some beautiful note cards out of it instead! We had a blast doing this as a fun summer project, and my oldest daughter adored making a wedding card for a newlywed couple's wedding we attended a few weeks ago. This is an easy project to do, but I'd plan on making this when you have a whole day at home where you can work at it a little bit at a time throughout the day.
Supplies needed:
-1 and 1/2 cup of shredded or ripped newspaper
-hot water
-spatula or whisk
-towel
-aluminum foil or felt
-rolling pin
-a notecard to use as a liner
-numerous sheets of un-shredded newspaper
Start by ripping up some newspaper - enough to fill one and 1/2 cups full of paper.  Be sure these are compact cups (one cup can hold more ripped up paper than you may realize!).  Then dump that into a mixing bowl and fill the bowl with hot water until it covers the papers.
Let this sit for at least an hour and stir.  I placed mine outside in the sun to keep the water as warm as possible.  I left this outside for a few hours - the longer you let it soak in the sun, the faster the newspaper will break down into a pulp.  This is why I mentioned earlier that you will need to set aside a day when you are home, so you can check on the pulp and stir once an hour for a few hours.
Next you need to make a foil template that will be used as a sieve to hold and drain the paper mixture.  I want to make a 4 x 5.5 piece of homemade paper that was the same size of other notecards that I purchased at Michaels.  I'll use the notecard as a liner inside of my homemade paper card.
Your foil will help drain water from the paper pulp if you poke holes in it with a toothpick.  Poke holes about an inch apart all throughout the 4 x 5.5 piece of aluminum foil.  You could also use a piece of felt as your sieve as well - felt will soak up some water and will easily peel off from the homemade paper.
After a few hours of the newspaper sitting in warm water, and stirring it from time to time, you should get a nice pulp that is similar in consistency to what is pictured above.  It may be lumpy, but you should not see any real strips of newspaper left - instead just clumps of paper fibers.
Next you will want to add 2 tablespoons of cornstarch to a baking pan.  The cornstarch will give the paper a little more of a sturdy texture. Then pour in the pulp into the glass pan and stir.
You will want to take your foil sieve and dunk it into the baking pan, making sure to cover it with as much paper pulp as possible. Slowly lift it out of the pan and try to make sure it is the same thickness of pulp throughout.  You may need to just grab some pulp with your hands and place it on the foil sieve to make it even.
Now it's time to get the paper pulp as flat and dry as you can.  Cover the top of the pulp with newspaper and use a rolling pin to roll out the extra water and create a flat piece of paper.
You could also place an old towel under your paper to help soak up water as well.  Roll the paper until it is flat and as much water has been squeezed out as  you can.  Once one layer of newspaper has soaked up water, you can peel that off and roll the paper again with dry newspaper to soak up even more water.  Be sure to pinch together any holes that you see in your paper - you want the pulp to be evenly spread with no holes!
Once the paper is rolled and as dry as you can get it, stick it on a window to 100% dry.  Then peel off the foil or felt. As it dries, it will give you a nice flat side from the glass.
The paper won't fully dry for at least 24 hours.  When it is fully dry, it will probably need to be scraped off using a metal spatula
There may be some paper residue left on the glass - but it cleans up n a flash - especially if you use the Norwex Envirocloth and Window Cloth! 
Once the paper is dry, it is time to decorate it into a lovely notecard.  I grabbed some leaf ribbon and washi tape, along with a blank notecard to make my final product. You'll also need a glue stick to attach any dried flowers you want to use.
Your recycled paper won't make a perfectly flat or even piece of paper, but I like that - it gives it character.  You can experiment with adding tissue paper, glitter, other fibrous material, etc. to your paper pulp embellish the look of it.  I just left mine plain for this first project.
Here is my final version decorated with gold ribbon, turquoise washi tape, and a dried & pressed daisy. GO HERE to read how I used an old college text book to make my pressed flowers. Also you can see my 7 year old daughters adorable version of a card for family friends!
Resources for this project:
See all materials
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page.More info
Maura White
Want more details about this and other DIY projects? Check out my blog post!
Go
Frequently asked questions
Have a question about this project?
  1 question
  • Kzk10443310 Kzk10443310 on Aug 02, 2018

    Can you use baking soda instead of corn starch ? kzktteppo7@icloud.com. Thxs

Comments
Join the conversation
3 of 81 comments
  • Nancy Blue Moon Nancy Blue Moon on Aug 26, 2018

    Your card turned out very pretty Maura...thank you for making each step so clear to follow!

  • Maura White Maura White on Aug 26, 2018

    Yeah I don't know who Carol Duvall is LOL! But I did learn this technique over 20 years ago in high school art class. I know this isn't new. But not using a blender to get the paper into a pulp was new to me. It's ok if projects are new or not - this is a community to share inspiration and ideas - not brand new inventions.

Next