Upgrade Your TV Stand Without Buying A New One
My daughter bought a new 55" television and it didn't fit on her existing TV stand.
The existing stand is really nice and she didn't want to buy a new stand so I had to make it work.
Step 1: Extending the top
After measuring the width of the new television, I purchased a piece of pine that was 3/4" x 16" x 48". This would give her a few inches on either side.
Step 2: Edges
I could have attached the pine to the top of the stand and called it a day but I wanted to finish it so I purchased 1/4" wooden trim for the edges.
Step 3: Measure
To assure the measurements were correct, I placed the piece of trim along the edge of the board and marked the measurement instead of using a tape measure.
Step 4: Cut
Using a miter saw, I cut all of the trim pieces to size on a 45 degree angle.
Step 5: Nail
I pre-nailed wire brad to the trim pieces before placing them onto the pine board.
Step 6: Wood glue
I applied wood glue to each edge of the pine board before I nailed the trim.
Step 7: Attach trim
I lined up the trim board and nailed to to the pine board.
I followed Steps 3 - 7 for the two shorts sides and the long front. I didn't put trim onto the back of the board since that would be facing the wall.
Step 8: Measure
Once the trim was attached, I measure the overhang of the pine board on the TV stand making sure it was centered.
Step 9: Attach the top
A - I drilled two holes into the pine board
B - I used a larger drill bit counter sink or make sure the heads of the screws were below the board. I only drilled down about 1/8" with this bigger bit.
C - I screwed the boards fast to the TV stand.
Step 10 A&B: Fill holes
A - I used wood fill to fill the screw holes
B - and the mitered corners
Step 11 C: Sand
Once the wood fill was dry, I sanded it smooth and removed any dust with a soft cloth.
Step 12: Stain
I stained the new top with Minwax stain with polyurethane in "Espresso".
Step 13: Attach to wall
To insure the stand wouldn't fall over, I attached it to the wall.
1 - I used one furniture strap
2 - I measured the back of the stand
3 - and attached one end of the strap to the stand following the manufacture's directions
4 - I attached the other end of the strap to the wall
5 - I pulled the strap to shorten it, bringing the stand close to the wall
6 - until the stand was about 6" from the wall
Now my daughter can watch her new HUGE television and be confident that it fits safely on her TV stand.
Enjoyed the project?
Suggested materials:
- Pine board (Lowe's)
- Furniture straps (Lowe's)
- Screws & wire brads (Lowe's)
- Minwax stain (Lowe's)
- Wood fill (Lowe's)
- Trim board (Lowe's)
- Wood glue (Lowe's)
Frequently asked questions
Have a question about this project?