Large Poster Display
I picked up a large poster from my local thrift store which I loved (I’m Australian☺️), but as it was over 100cm wide (approx 3 foot), I found it very hard to find an inexpensive frame for it. So I decided to try something different.. 😊
I had some pine mouldings/trim in the shed (left over from another home project) so I measured up the width of the poster and then cut two pieces of the pine to that size.
Next, I grabbed some super glue and put a line of glue onto the flat side of the pine moulding.
I then glued the mouldings to the top & bottom of the poster. I pressed down on it for a few minutes to make sure it was evenly glued the whole way across.
Next, I got 2 small screw eyes and screwed them into the pine moulding at the top of the poster, one at each end. As the pine was fairly soft, I didn’t pre-drill holes, I just used a bit of pressure and pushed them in by hand while turning them until they were tight.
Lastly, I grabbed some white cord from my craft supplies and tied it to each screw eye.
Then I found a spot for it on the wall. Done! 👌🏻 A simple & cheap way to display a large poster. 👍🏻
Please check out my other DIY projects on my Instagram page @_prettyliving
Frequently asked questions
Have a question about this project?