30-Minute Cutting Board Storage

Amanda
by Amanda
3 Materials
30 Minutes
Easy

One of the joys of being a hobby woodworker, is that you always have small scrap pieces of wood. This is the perfect project to use some of those scraps!

Our cutting boards had been using up some of our minimal kitchen drawer space for years. Finally, I decided to make them their own storage area on the back of a base cabinet door.

Like I said before, wood scraps are perfect for this. I used some 1x3 pieces for the bottom and sides, and some other scrap pieces trimmed from a 1” board (approximately 1” x 3/4”).

Decide where you will be putting this and measure the useable door space and your largest cutting board. Be sure to leave a couple inches on the non-hinge side so the door can close without hitting the frame.

*Also take the door structure into consideration (ie- thickness at the sides vs. the center or where the trim is located on the front.

Cut the bottom of your cutting board holder slightly wider than your largest cutting board. Cut sides to be around half the height of your board or more. (Learn from my mistake — my sides are too short and the cutting boards flop a lot when the cabinet is opened or closed quickly.) You also want to take into account the height of your shortest board. If there is a big difference between the two, make sure your sides are shorter than the shortest board.

Bevel the top from edge of the sides by snipping off about an inch at a 45° angle.

Attach the sides to the bottom with wood glue and nails.

(I put glue and a clamp along the bottom until I cut and attached the small pieces to help keep it square, then pre-drilled and attached finishing nails to prevent splitting.)

Cut your small pieces to the total width of your holder. You can also bevel the front edges of these if you want.

Attach with glue and nails. The first should be close to the bottom (one inch max from the bottom board, or less if you have thin, flimsy cutting boards), and the second should be directly below the beveled cut of the sides.

Attach small corner braces to the inside edges of the sides.

Attach to your cabinet, making sure your screws don’t go through the other side.

Add your cutting boards and enjoy!

Feel free to paint or stain your holder to match your decor.

I was working on this during my kids’ nap time, so I knew I wouldn’t have time for painting, but will probably paint it at some point.


Resources for this project:
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page.More info
Frequently asked questions
Have a question about this project?
3 of 4 questions
  • Ann Ann on Aug 21, 2020

    I love the idea of this for easy access to them, but doesn't it take up the interior cabinet space when the door is closed? I always have that problem.


  • Mona Plunkett Mona Plunkett on Jun 05, 2021

    I love this idea but I have those cheapo hollow doors on my cabinets. Will this work as well on them or is the weight a factor? I have lots of different sized cutting boards and this is a dandy idea.


  • Lynn Lynn on Jul 04, 2021

    It seems that adding all that weight to a cupboard door would put a lot of strain on the hinges?

Comments
Join the conversation
2 of 14 comments
  • Mary Ellen Mary Ellen on Jun 25, 2023

    Love this project! Thanks for Sharing!!!!

  • Janice Hodge Janice Hodge on Jun 25, 2023

    I love the idea but in my situation it would interfere with the cookie sheet pans etc in the cabinet . So I did the next best thing and stood them on their sides along with the cookie sheets and the thin boards I placed on the door with a command hook .

Next