Step 1: Sand down the PVC cap

Sand down any words or rough spots that might be on the PVC cap. Get tutorial here

Step 2: Drill holes on opposing sides

Drill hole toward the open edge of the cap on one side. Mark a spot directly across and drill another hole. Get tutorial here

Step 3: Mark and cut a wide strip of leather

Take a ruler and mark an inch wide strip with "V" shaped ends. Make it as long as you wish. Get tutorial here

Step 4: Pull the strip ends through the holes

Thread the strip through the hole long enough to allow for them to reconnect past the edge of the PVC. Get tutorial here

Step 5: Fold stripes and pierce holes through

Pierce holes through the leather straps using knife / awl / or eyelet pliers, just above the PVC edge. Get tutorial here

Step 6: Screw bolts through the holes

Place a short bolt through the holes on each side of the PVC and screw into a nut on the other side. Get tutorial here

Step 1: Start gluing a box shape together

Lay one mirror on the mirror side and hot glue on a second mirror vertically with the mirror facing out. Get tutorial here

Step 3: Repeat until the box is complete

Don't bother removing the labels since the box will be full anyway. Get tutorial here

Step 2: Make an incomplete box for planter

This is for the planter portion. Build it in dimensions matching the board you cut previously. Get tutorial here

Step 3: Glue the box to the board

Measure 1" over from the left and 1" up from the bottom and glue on the box. Get tutorial here

Step 5: Hammer nails on top and remove paper

Once you are done nailing in the design just remove the paper from around the nails. Get tutorial here

Step 6: Sand edges and stain/paint the board

You will also want to seal it for the outdoors with a Thompson's sealer or something similar. Get tutorial here

Step 7: Attach hangers on the back

You can simply screw in 2 short screws into the wood at an even level and then twist a piece of wire around them. Get tutorial here