Asked on Apr 30, 2018
Cutting very thin plywood- Is there an easier way?
I need to cut sheets of very thin (1/4" or 1/8") plywood. They are full-size sheets and very floppy, either dipping in the middle or haning over the ends of the saw horses. Is there an easier way? I have a box knife and a jigsaw.
3 answers
-
![Ireland Dowling]()
Ireland Dowling
on Apr 30, 2018
Use masking tape on each side. this will make the cuts on point and prevent any splintering. If possible, your best bet is to have it cut in the hardware store you purchased it. They will cut it at no charge. -
![Sharon]()
Sharon
on Apr 30, 2018
Put a few long boards like 2 x4s under the plywood across the saw horses the opposite direction. Then just move it over after you have cut up to it with your jigsaw. I would put a piece of tape on the cut line to prevent it from splintering. -
![1401470]()
1401470
on May 03, 2018
If you can get someone to help hold the wood for you while you cut that would be best. We use our table saw with a fine blade.
Sign Up to Answer
Suggested Project Book
