DIY Dollar Tree Wreath
This is a fun and easy DIY wreath! Lately, I have seen so many wreaths made with wooden beads and greenery so I decided to make a knockoff version using ping pong balls!
Check out what I did below.
What you’ll need:
4 packs of ping pong balls (they come in packs of 6 from the Dollar Tree)
14” wire wreath frame
Rustoleum paint (Smokey Beige)
Drill and bit
Start by taking the wreath frame and cutting it.
We will cut it all the way around except we will leave one section untouched. Also, we will leave the second wire on all the way around.
This is how it will look like once you have finished cutting. You can see here that the second ring is left on.
Now, you will cut that one wire. Cut it where the cross bars were and try to cut them as close to the wire as you can.
Drill a hole in the middle of each ball going all the way though. Be careful to hold them by the sides so you don’t drill your hand!
Once you have done all the balls slide them onto the cut wire ring.
Once you fill up the ring you’ll want to put the 2 wires in the balls. To keep them together, glue the end balls to the balls next to them.
Now it should look like this.
Take it outside and lightly spray paint it with the Smokey Beige to make it look like natural wooden beads.
Now, grab your floral foam and use your floral tape and cut to fit in the wire space.
Take your flowers and place them in the foam blocks, filling it up the way you like.
I made some go up and some go down.
Now it should be done! What do you think? Share your comments below and if you’d like to see more DIYs follow me on Facebook, Instagram or YouTube at Gilbert Marketplace.
Can you believe this cost less than $10 to make? See more diy on YouTube Gilbert Marketplace!!