How can I cut wine corks lengthwise in half and have them all be even?
I'm going 2 make a few memory boards for a few coworkers. How in the world do I cut them and they all be even.I need them longwise not across. Any suggestions, tips or hints would be amazing. Oh, all I have is knives and a hacksaw. (Victim of a burglary.)
Do all sewing machines have a presser foot tension regulator?
I am a mid to intermediate level seamstress. I've had two machines over the past 40 years, a Kenmore, followed by a White sewing machine, both very nice sewing machi... See more
How do I open this tube?
The end of this tube is very hard. I slightly tried to punch the end of a knife into it and also tried a large paper clip but neither budged it. I was a bit timid in ... See more
How can I stiffen crepe paper?
HelloIs there anyway I can stiffen crepe paper leaves?
What type of saw and blade's do i need to slice/ cut agates?o
How do you glue the plastic that water bottles are made of ?
What kind of glue works with polyethylene plastic ? I have tried many kinds with no success.
Where can I find furniture decals?
How do I still use this if the cap/tip is broken???
I don't wanna have to go buy a new one bc this was only used 2 times I have a quick job to do but I don't know what to do bc it broke.. help!!!
Here you go:
Hi Samijo. I'm Cindy. If you steam corks they will be easier to cut. Place a steamer basket inside a pot with a few inches of water. Allow the water to come to a boil and then put the corks in the basket. Put the lid on and let them steam 10 mins.
Here's a post that might help you - https://wine.lovetoknow.com/wine-articles/how-cut-wine-corks-evenly
Sharp electric Meat cutter Knife maybe .Or it could be a sharp craft knife. Wear Protective gloves and be careful..........
I would make some kind of jig to immobilize the cork with an opening at the top and bottom of the cork so the hacksaw blade can move back and forth.
Hello, hope this helps you out some