5 Easy Steps to Lay a Vinyl Tile Floor

9 Materials
3 Hours

I had my doubts when we decided to use peel and stick vinyl tile for the floors in our half bath. Could something so inexpensive actually be of good quality? There was plenty of information on the web, but it was mixed reviews and so confusing. Now that the installation of our new floor is complete, I've come up with 5 easy and basic steps to make the project super simple and I'm sharing my review on the product I used.

When I was trying to come up with a design plan for our half bath remodel, I came upon this lovely patterned vinyl tile. I couldn't believe it was peel and stick and to be honest, I almost moved on with my search. But after doing some research I decided it was worth the risk, so I bought it. When it arrived I was actually surprised by the quality of the tiles but still concerned because this bathroom is the only one on our first floor and does get a lot of traffic.

Bathroom floor-Before

After we gutted the entire bathroom this was the floor we had to work with. Not exactly what we expected. On top of there being water damage, two areas in the floor were totally uneven. In the end we had to tear out the whole floor and start over.

Once we reinforced the floor and installed a subfloor of 5/8" plywood it was time to start tiling.

Supplies needed:

Vinyl Tile -We used Floor Pops Peel and Stick

A good quality primer (if you are starting with a plywood subfloor).


Calk Gun (for adhesive)

Measuring Tape


Retractable Razor Blade

Rubber Roller

Damp Cloth

To ensure proper adhesion we applied one coat of paint/primer to the subfloor and allowed it to dry overnight.

Step #1 - Find the center of the room

Using your pencil and measuring tape draw a line horizontally and vertically from one end of the room to the other.

Step Two-Lay down your first tile and work your way out, matching the tile pattern (if you have one) as you go. Since many of the reviews on the product we used stated there was an issue with matching up the pattern, we did a test run. ***We did not have any issues but we did purchase an extra box of tiles just in case.

Step Three: Apply a thin line of adhesive on the subfloor for each tile. **The tile does come with a sticky adhesive which I'm sure is plenty good for most projects. But since our room does get a lot of traffic we decided to add more to be on the safe side.

Step Four: Remove the paper backing from the tile and press firmly into place.

Step Five: Use the roller to press out any excess adhesive and air bubbles. **If any adhesive seeps out use the damp cloth to wipe up immediately.

We allowed the tile adhesive to set up and dry completely (1-2 days) before we washed the floor.

Resources for this project:
See all materials
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page.More info
Pallet and Pantry
Want more details about this and other DIY projects? Check out my blog post!
Frequently asked questions
Have a question about this project?
3 of 16 questions
Join the conversation
3 of 32 comments