Asked on Dec 02, 2018

How do I replace the handle on this lid?

by Sharon

The handle came off and I am looking for suggestions as to how to replace it. I don't know if solder will hold it. I am not willing to drill holes in the lid. Suggestions?

q handle lid separation
  5 answers
  • Kelli L. Milligan Kelli L. Milligan on Dec 02, 2018

    It looks like an epoxy glue. Try JB Weld. It's a glue for metal.

  • Deb K Deb K on Dec 02, 2018

    Hi Sharon, the handle looks like it still has bolts in it, if you can remove them, maybe you can find some around the same size and put them in they may hold

  • Lynn Sorrell Lynn Sorrell on Dec 02, 2018

    JB Weld handles heat up to 500degrees

  • Shah Shah on Dec 02, 2018

    def looks like the screws are gone go to hardware get new ones or maybe small nuts and bolts you probably will need a washer between the handle and lid but should do the trick

    • Sharon Sharon on Dec 02, 2018

      Not screws. No holes in lid. It has has some type of solder or weld type connection but thanks anyway.

  • Shah Shah on Dec 02, 2018

    follow on sorry you will prob have to drill couple small holes to fit it i thought they were already there but would be the way i would do it