what to do to prepare slice of tree for table project
-
John P on Apr 02, 2012seal the end grain with a good sealer and let the pc air dry or send it to be kiln dried down to about 7% moisture then it will be ready for planing and finishing also make sure it is stored flat and level and wieghing it down can help alsoHelpful Reply
-
-
KMS Woodworks on Apr 02, 2012End grain slabs tend to check or split more so than vertical "slabs" I would seal it up with some Anchor Seal...let it dry for a good long spell (normal air dry times are 1 year per inch of thickness) once dry some good sanding and a number of finish coats. end grain will absorb much more finish and it will take some time to get a "finish build" going. With a product like Minwax's wiping poly about 7-8 coats http://www.uccoatings.com/products/anchorseal2Helpful Reply
-
-
Elinor A on Apr 02, 2012Thank you for the suggestions but this doesn't answer my question because the entire piece is end grain this is a horizontal slice thru the main stem close to the bottom of the tree. and when you say seal what is considered a good sealer thanks for all your helpHelpful Reply
-
-
John P on Apr 02, 2012band it with a good wide ratchet strap and let it dry i would say approx 9 months to a year you want it to be under 8% moisture for best results then sand stain and seal it will take a few coats of sealer a good poly resin works well alsoHelpful Reply
-
-
KMS Woodworks on Apr 03, 2012Elinor...the Anchor Seal I Mention above has been the "industry" standard for sealing end grain on lumber for 30 years or so. When I purchase lumber for turning projects nearly every piece is sealed on all six sides with anchor seal. I have seen anchor seal for sale on ebay and amazon as well as many woodworking supply sites. John's idea above about a ratchet strap is a great idea...the log slice should be stored on its side so the seal ends are open to the air and not resting on some surface. I have worked with smaller sized "slices" for various projects. My girls call the really small 2" dia ones "tree cookies" The largest end grain round I have worked with was about 14". Bigger than that and it will not fit my lathe. Some of the longitudinal slabs I have worked with were 6 to 8 feet long and up to 2' wideHelpful Reply
-
Related Discussions
How do I clean off Black toilet bowl crust?
Hello, how or what can I use to clean the bottom of my toilet bowl? Is has a black crust
How to change a Zipper colour?
I have a lovely pair of black boots with silver zippers. I would like to change the colour of the zippers, 2 on each boot, to black without screwing up the zippers...... See more
Do you recommend painting the inside of a fence?
I have a small patio and think about painting my fence on the inside so I can put some colorful decor up. Is this a good idea?
Why is there a noise coming from my electrical outlet?
I have noticed a noise coming from one of my electrical outlets. It sounds like it is buzzing. What could be the reason for this?
Painted wood: yay or nay?
Let's dive into the age-old debate: painting wood. Some homeowners swear by the transformative power of a fresh coat of paint on wood surfaces and furniture, while ot... See more
Thompsons Water sealer disaster
Since we just had our deck pressure-washed, we decided to apply Thompson's Water Sealer to help preserve it. Big mistake. It seems to have a permanent stickiness. Any... See more
Are gray walls here to stay or are they on their way out?
Hey everyone,Gray wall color has long been a favorite choice due to its versatility, modern appeal, and ability to complement a wide range of design styles.But the qu... See more