I redid my tub, with tub paint, now the paint is peeling, any suggests
-
Walden Enterprises on Jul 01, 2013Lisa - even though you may have followed all the directions on the can, it sounds like the problem is adhesion at those spots. If you used the product from a home improvement store that comes in a kit (with a cleaning solution, steel wool, gloves, etc.), you could try just doing the whole process again, being extra diligent where it is peeling. I will tell you that there will be some texture difference where the peeling stops. This tub paint just does not have the "build up" that other paint has. If it really begins to peel, just go for it and remove as much as wants to even think about coming off and then prime with a product called XIM, available at Sherwin Williams. It is a super strong oil-based primer that will bond and seal the surface. Then, re-apply the tub paint and you should be good! Still cheaper than a pro! Good luck. Oh, and be sure and ventilate your work area properly - this is VERY stinky stuff and can be dangerous. No open flame near the work area!Helpful Reply
-
-
KMS Woodworks on Jul 01, 2013Most paint failures have to do with improper of insufficient prep. If you were working from the "can" I would think the latter. A little residual moisture or a bit of soap scum is all it takes to pose problems. You may have some luck reworking those areas taking extra time in the prep.Helpful Reply
-
Related Discussions
My cabinets are peeling. Is there any kind of paint I can use in them?
How do I strip off the covering before I paint? I would like to paint either white or light gray. Can this even be done?
Old desk with hard rubber top needs help
I have a very old desk that is in great condition except for the top. It is that old, hard rubber and it has a lot of dings and gashes (for lack of a better term). I ... See more
Do colors have to coordinate for bedroom and bathroom?
I recently got overzealous and bought a shower curtain, towels and rug for my bathroom in a totally different color than I planned on doing in the actual bedroom. Doe... See more
Should I remove plaster and lathe or can I just remove plaster?
I have an 1882 Balloon construction house that has some pretty extensive plaster falling off of the lath. I know that the lath actually adds to the wall stability, a... See more
How do I remove sand paint from the walls of a small bathroom?
Thought it was clever and a great look until I realized that if you fall against the wall it would scrape worse than a fall on cement. My husband is elderly and the l... See more
Has anyone had any luck removing artillery fungus?
Please provide personal success stories on how to get rid of fungus in mulch... not links because I have googled and watched others and tried. My daughter had a load ... See more