We had our deck rebuilt last February, and stained last week. I'm not happy with it because the stamps on the wood show
-
'Raven E on Jun 12, 2012when working with stain and wood i always sand away the stamps before staining, i dont know if that is how normal people do it :D good luck!Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Jun 13, 2012The prep for the staining was not done correctly. If there is any stamps on the deck surface, they need to be cleaned off and the board(s) sanded to allow the stain to be accepted to the surface in an equal way. You may be able to sand those areas and re-stain them so they blend into the new finished surface. But do not wait to long as the stain will fade and the new stain will not match for some time after it is applied.Helpful Reply
-
-
KMS Woodworks on Jun 13, 2012Part of the problem lies in your lumber choice and how it was installed. Higher end decking is not stamped ( like tropical hardwoods) softwood lumber may or may not be stamped. When the lumber is installed the installer should have set the boards with the stamps facing down not up...I have yet to see lumber stamped on both sides. If the stamp side was exposed then it should have been prepped better...by sanding. I have found that 80 grit keeps the wood rough enough to prevent glossy areas when semi- or transparent stains are used. To fix this you will need to sand as Woodbridge mentioned above, ideally the sooner the better. To minimize the sanded look you will want the "feather" out the sanding edges.Helpful Reply
-
Related Discussions
Cleaning mineral deposits off of glass
How do I remove mineral deposits from windows??? I've tried cleaning with vinegar on both the inside & outside of the windows...is it possible it's on the inside of t... See more
What to hang over fireplace?
Right now I have a cream colored berry wreath over my fireplace. I will be getting the picture shown over my sofa ( that is a mock up so size won't be exact). Do you... See more
Clean grout hard (iron) water stains?
We have a shower that has laminate side and flooring. The areas were grout is has turned orange/Black. I have used vinegar applied with toothbrush, Granite Gold grout... See more
Toilet: Rumbling / Vibrating Noise when FILLING up (SMOOTH when flush)
When flushing the toilet, no problem, smooth flush like all others, no issues. (My 1st inclination of the noise when filling up was a clogged toilet, but it flushes q... See more
How clean grout from a brick ?
hello all, I just moved to my new APT and I was working on my new kitchen. part of the work is to glue the bricks on the wall 1 centimeter apart so that the grout ... See more
I need a fabric stiffener that is weather resistant. Any ideas?
I created a fabric wreath and have tried two different brands of fabric stiffeners that have failed, any help appreciated.