Chinese Lanterns From Soda Cans
Cut upcycle soda can lanterns using LED lights! ***CLICK HERE FOR MORE PICS, A VIDEO & MORE DETAILS*** NOTE ABOUT SHARP EDGES: These typical soda cans are now made from VERY thin soft aluminum. It would be incredibly hard to get cut on it. Our hands were in and out of the sliced cans and we didn't get even a scratch.
Soda cans (with tab still attached )
Spray paint
Tea Lights, Timer/Battery Operated
Utility knife
Raffia etc. for hanging
You can measure around the can and make tiny marks where you will cut. You can also just eyeball it and cut, which is what I did. Make sure to keep the tab on!
Fill the can with water to about 1/2″ from the top and freeze. If you fill it too full it can split the can. Because the can's are so thin you need the frozen water so that you can easily cut the slits in them.
Make cuts with a knife about 1/2″ apart and about 1″ or so from the top and bottom.
Spray paint your can. You're now ready to shape it!
Carefully push down, making sure the cuts go outward.
Slide in a tea light if you're using one.
***THERE IS A VIDEO OF HOW TO MAKE THE CAN ON OUR POST LINK BELOW***
Enjoyed the project?
Resources for this project:
See all materialsComments
Join the conversation
-
Don Ruppel on Aug 02, 2023
You said it is almost impossible to get cut on these cans... ever hear of paper cuts ? Paper is thicker than these cans and yet you can get cut on it.
-
-
Rok20418589 on Aug 08, 2023
Very hard to cut can...
-
Frequently asked questions
Have a question about this project?
can you string them and hang them? How hard ids it to take the tealight in and out?
How do you get the soda out of can if you have to leave the top on?