How do I stop my new rocking chair from walking across the room?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How do i stop my big LG front load washing machine from walking ?
When in the spin cycle my washing machine starts "walking". I have made sure to level it. The legs are properly adjusted. It spins so hard that a large bolt in the b... See more
How can I remove these water marks from wood tables?
My husband bought these tables and a few of them are in good condition while some have like water marks on them (not sure though). I would like to know what could I ... See more
An exorcism?? Sorry!
Ha! Good one. I like your sense of humor....👻
DON'T OVER WIND IT. IT'LL NEVER STOP =:) .....
It happens when if the rockers are loose, or ill fitting then they will move slightly when rocking or when there’s not enough friction between the chair and floor. Turn the rocking chair upside down to allow free access to the rockers. Make sure they are not loose. Hold a piece of cardboard against the outside of one rocker. Trace the outline of the rocker onto the cardboard with a pencil. Hold the cardboard tracing against the inside of the opposite rocker and compare the two profiles. Mark the starting and ending points of the differing radius on the rocker with the higher arc. Rocking chairs require both rockers to have the same profile radius in order to move back and forth in a straight line. When one of the rockers has a higher arc, the chair has a tendency to “walk” in the opposite direction. Reduce the arc of the higher rocker to match the flatter radius with some sandpaper. Compare the rocker’s profile with the cardboard outline every so often so not to sand too much......
Glue a strip of felt or velvet ribbon onto the bottoms of the rockers. This should stop rocking chairs from sliding around on smooth surfaces, as it creates more friction between the rockers and the floor. Make sure the material you use is evenly spread out over each rocker and that there are no bubbles, otherwise your rocking chair might give you a bumpy ride.
Good luck!!! I got a nice laugh from the funny answers you got https://newengland.com/today/living/home-repair-diy/stop-rocking-chairs/
I was thinking maybe you could use those little rubber bumpers the rails to help keep it in one spot.
I bought a cheap dollar store scatter mat and put it under the rocking chair. Problem solved.
Well, after much thought...I've decided that Comment #1 would definitely be the easiest. And possibly the most interesting. We did switch the rockers to see if that helped and it may have helped, but just a little. I had a low pile rug under it and that did nothing. I have a funky rug that has quite a bit of texture/pile to it and that's where we're at now. I am still leaving Comment #1 up for consideration!!
When I was a kid we had a rocker that walked across the floor. We never did figure out how to stop it, so it was a repeated moving the chair back in place. One time, a neighbor brought a big miller (I call them Hummingbird millers) to me and I kept it in the house. We had it for weeks and we all enjoyed the little critter. One day, it sat on the floor by Dad's rocking chair and accidentally got rocked on! Moral of the story, watch out for those tiny pets that they don't get under a creepy rocker! : )
Take a piece of rubber about one quarter of an inch thick and one foot long and glue it to the bottom of the rocker on both sides, it should stop the scooting.
Wrapped a heavier rubber band, several times, around each leg of rocker. No more "walking".
Years ago we purchase one of those relatively inexpensive "bent-wood rockers" with the cane seat and back. It also "walked" and we finally sold it because it was so frustrating. We figured we had to be off our rockers to have purchased it. :)
https://newengland.com/living/how-to/stop-rocking-chairs/
Glue a strip of rubber to the bottom of the rockers.
Hi Cindy: Get some of that carpet backing that's non-skid, like the shelving liner, and put it under the legs of the chair.