What are some tools and techniques to sand chairs with lots of curves?
Related Discussions
Can I ask Home Depot to cut my wood?
I'm seriously considering making this twisty side table that I fell in love with here on Hometalk (By Chasing A Dream), but cutting the wood is a bit too ambitious fo... See more
What to do with our livingroom ceiling?
We took the old popcorn ceiling off in our livingroom and thought we could just paint it. We fixed some hairline cracks where the joint in the sheetrock are, primed a... See more
What type of hinges are used on the top of this folding table?
Does anyone know what type of hinges are attached to the top of this folding table? The legs fold in toward the back then the top folds down flat against the legs.
How would I be put on these wheels ?
I am planning on doing a mobile wood bench using 2x4. I have these wheels but have no clue to put them on
Sealing/smoothing crate wood
I am turning the sides of an old wooden crate into a coffee table top. The wood is similar to pallet wood: unfinished and prone to giving splinters. How might I go ab... See more
How do I make DIY furniture sliders to move heavy furniture?
HOW DO I MAKE FURNITURE SLIDERS TO MOVE HEAVY FURNITURE.Best furniture sliders!Move furniture easily with Round furniture moving kit that Amazon reviewers swear by!
I use sponge sanding blocks. Short lengths of different size dowels I wrap sandpaper around. 1 x4 and 2 x 4 blocks of wood wrapped with sandpaper. A lot of hand sanding.
Thanks William! Never thought of those suggestions. Sounds like they will get the job done.
I use flexible sanding pads. They used to carry them at Home Depot, but they haven't been in stock lately, so I order them from Amazon. I also use a mouse sander with an attachment to get into as many areas as possible. Good luck with your project Bob!
I'm not sure how far you are taking it down, but they do sell liquid sander deglosser at home improvement stores and also Citra solve works great too its a stripper. Those may help you take a finish down quite a bit and save you some sanding if it has a lot of curves and it isn't too easy to get it all off?
If you use a liquid remover, like Nikki suggested, you can use knitting yarn or string to get down into those tight places like some furniture legs have. A spoon can be used to remove it in the depressed areas. Just be careful not to apply too much pressure, or it might gouge the wood. You might also use Q-tips in places where appropriate. A plastic or metal putty knife will help speed the removal on flat surfaces.
I like fine steel wool and a very small wire brushes about the size of a toothbrush I get in a 3 pack at the dollar store, or a firm toothbrush.