How do you make the perfect miter cut?
Related Discussions
Chair rail height?? At the sill or below or around?
I am running chair rail around a bedroom. The marble sill is 40" from the floor the window is 39" high. Putting printable wallpaper on the bottom. Painting the botto... See more
Best nail gun?
I am very new to working with tools and am wondering what the best type of nail gun I should buy to work with pallets. I am interested in redoing a wall with pallets ... See more
How can I seal old chipped wood?
I have a few amazing pieces that are old and the paint is chipping. I love them just the way they are but hate the flakes that constantly come off! What to do so it'... See more
How to make a magnetic picture board to display (travel) magnets.
Cutting a wooden spool
Can anyone suggest the best way to cut a wooden spool in half length wise. Approx. 16 "tall, ends are wood and the center is thick. I have several different power saw... See more
STEP 1.
I start by setting my saw to 45 degrees to make a four-sided frame, which I verify by making two test cuts and checking the resulting corner with a reliable square.
STEP 2.
I make a single miter cut on one end of each of the four frame pieces, and reserve an offcut for use as a stop block.
STEP 3.
With the mitered offcut clamped in place, acting as a stop block, I cut the other four miters. Sometimes, it is difficult to position the stop block exactly where it is needed right away, so I often make a few test cuts, moving the stop block closer to the blade after each cut.
Although miters may seem complicated, once you break down what makes a successful joint, I think that you'll find cutting miters fun and easy.
https://www.craftsy.com/blog/2015/07/miter-joints/
Lots of videos here.
https://www.youtube.com/watch?v=8uFL0U_LNIc
Tools make all the difference. Being a beginner wood worker, when I've used a table saw (borrowed), and set it at a 45 degree angle, I got really perfect cuts. I 've also used those yellow hand saw guides (plastic). Not as perfect, but still did pretty good.
Measure twice, cut once. Use the proper tools and a good saw. Practice on scrap wood. Best of luck.