What are essential tools needed for new DIYer for pallet projects?
Related Discussions
Anyone have ideas on how to repurpose potato chip canisters?
I'm looking for ideas on how to repurpose potato chip canisters other than storing food in them.
What should I do with this rusty bucket?
I love rusty junk. So when I saw this bucket at a yard sale I liked it too much to pass it up. The question now is, what do I do with it? My only thought is to turn i... See more
Creative uses for empty cat litter buckets, anyone?
Does anyone have any ideas of things to do with empty cat litter plastic buckets? I did take a foam square and covered the bucket and foam with fabric to make a quick... See more
Recycling Cat Food Cans
We now live in a rural area with no trash pickup. I am separating our trash and doing what I can to compost, feed the chickens, burn or store to take to the dump. I... See more
Pallets- where can I get them?
I've been to 2 Home Depots in my town and neither would allow me to take even ONE- where is everyone in the DIY WORLD GETTING THEM?
How to repurpose Meow Mix cat food containers
I can't get myself to throw these out because I think there must be a cool project for them.
Does anyone know where I can find free pallets?
I am beginning to make a little private garden in my drive. I have no yard but have a small parking area off my drive, plus another entrance. And of course limited in... See more
Hammer , pry bar, screwdrivers both flathead and crossed , table saw, mouse (hand held sander), some quality paint brushes . You can aquire the rest as needed (paint , stain, polyurethane, etc.) We have saw horses but almost never use them . Seems like every time we have to cut something , it gets placed on edge of the table in garage . It's whatever you're comfortable working with .
If your on a limited budget,you don't have to have a table saw. I started out with a hand held circular saw.You can make a cutting guide from plywood and get accurate cuts with that, You will also need some clamps. Always hold your work piece down when cutting. Check out the websites for Wood magzine, Woodworkers Journal, Shopnotes for tips and techniques. Also check out Rockler Woodworking Supply for tools ,parts and accesories. Good luck and have fun.
A reciprocal saw cuts them apart in no time. It cuts right through the nails cutting the boards apart without damaging the wood. Then you can work around the nails still in the wood. Most of them will not be in your way leaving you the whole length of board to work with. It's fast and accurate. I've cut many dozens of them.
I agree with Theresa, the reciprocating saw is best. It will give you more time to design and build. Tearing palettes apart is tedious.
Thanks to each of you. You've given me a good start!