Replacing kitchen cabinet hardware-handles to knobs. I have found that
by
Linda
+2
everything shows 2-3" from bottom of (upper cabinet) but can't find any measurement from other edge (inside)??
Related Discussions
Suggested Project Book
I would just update with new handles instead.You will have to fill in the holes which will be more of a project
https://taylorcraftdoor.com/cabinet-door-hardware-placement-guidelines/
I'm not sure I understand the problem. But typically if you remove handles (2 holes in the door) you need to use woodfil for one hole and the knob can use vacant hole. Hope that helps.
It can also be an aesthics thing, put them where they look good to you but make sure all the same measurements. I believe you can also get plastic templates that sit over the corner of the door so you don't have to run around with tape measures.
Just measured our. Hole is 3.5 inches up from the bottom of the door and 1 and 3/8 inches from the edge. Could be adjusted depending on the size of the knob. Ours are rubbed oil, round, and 1 and 3/8 inches in diameter.