How to replace a single, broken floor tile in the bathroom?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
Rubber backing on bathroom mats disintegrating. Any way to replace?
Carpet on mats are in good condition and I would like to replace the disintegrating rubber. Is there any product out there that can be applied and allow me to launder... See more
1950s tile bathroom floor lost it's shine
I have a 1956 ranch home. The bathroom wall and floor tiles in the house are original and in mint condition. My problem is the floor tiles. I cannot seem to bring any... See more
I would say the best way would be to start exactly where the break is and use a small hammer, plus a towel under the hammer, to chip away at it slowly and carefully. You will want to chip away the grout entirely around the broken tile and also from under the broken tile as well before setting in the replacement.
My advice, word for word! We grandma's must thing alike. If the new grout is brighter than the old, you could use some markers to make it match, but I would just leave it and let it age naturally. Oh, and try to stay away from the new tile, glue, and grout for three days to let it all cure in place. Best wishes đŸ˜‡
I would suggest a hammer and chisel carefully work from the center of the broken tile till you are able to remove it in pieces. It's a little tedious but you will be able to remove the tile without damaging the floor. I'd use a painter's drop cloth to protect the rest of the floor. Be sure to remove the grout and any adhesive as well so you can set the new tile perfectly.
you hsve to try and chip it out carefully with a chisel then replace