We have a covered entry way where the previously installed tiles have failed/broken up.
As I cleaned/took the tiles off, the sharp edges of the surrounding concrete broke off leaving ragged edges that need to be trimmed off in order to re do the tile or even just to fill the area with concrete. Want to know:
1. Is it possible to clean-cut the existing concrete?
2. Is it possbile to patch(repair) the existing ragged concrete edges?
Would greatly appliciate any comments and/or suggestion.
Yung
Attachement: a picture showing the area.
-
Dan's of Central Florida, Inc. on Aug 10, 2011Hi there, Repairing just a ragged edge with concrete is going to be a tough job. You might be able to get a saw with a cement cutting blade and slightly angle the cut so as to chop off the broken bits and make it a smooth edge. How far are you going with the new tile (you mentioned redoing the tile)? Just on that one section or more? How badly is it chipped? Can we get a close up photo of the damaged sections?Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Aug 10, 2011You are best served to remove the damaged cement section and replace it with new. By the photo it looks as though there was some reaction from the cement slab to the tile that was installed. Although not an expert in this area I would think that perhaps water has seeped under the stone facing and caused the cement surface to spall due to salts released in the cement when they come into contact with moisture. Any patching would eventually fail in any case. With the amount of work it takes to get the job done right its sometimes better to go that little extra mile and make it last.Helpful Reply
-
-
Itsreally C on Aug 10, 2011its not difficult IF its your specialty but, for the avg diy'er, its not easy. 1st, you need specialty materials; 2nd, diamond blade & grinder, 3rd, knowledge & experience. patch the spalls w/white cement concrete dusted w/some coloring agent & quit hitting the adjoining slabs w/your hammer - that's why they make brick chisels ;-)Helpful Reply
-
-
Yung W on Aug 10, 2011I though one can have a close up of the picture I attached. if Not I will take a closeup of the edge and forward it to you as needed. Edge is about an inch deep defining a 3'x5' area or a hole, and the edge is irregularly broken off !!! So we need to trim off to made a clean edge for tile job.Helpful Reply
-
-
KMS Woodworks on Aug 11, 2011Yung...You wouldn't happen to be a software engineer per chance? The layout of the removed tiles are screaming "order and precision" Is this in a finished garage? it looks like an epoxy coated floor in the foreground. One option that is somewhat DIY friendly would be to add tile to the face of the "riser" Then tile over this new edge. Using a cement based thinset will provide a "concrete" like surface. It look to me like maybe the old install used a latex mastic that was somewhat compromised. The adhesive or mastic residue on the stoop will need to be ground off, smoothed or removed before new tile can go down.Helpful Reply
-
Related Discussions
What to do with the top of this piece of furniture?
I am planning on using the bottom as a credenza in my dining room any suggestions what I can do with the top?
How to get rid of tomatillos bugs?
Sow tomatillos this year, and couple days i notice it they are been bitten i look around and i found some disgusting creatures, I've healthy plants besides these inci... See more
Can You Name These Michigan Weeds? Are they, indeed, weeds?
The annual invasion is upon me... and I don't even know their names and I am not even sure that they are weeds.... can anyone identify/name these weeds? Some are even... See more
Cleaning mineral deposits off of glass
How do I remove mineral deposits from windows??? I've tried cleaning with vinegar on both the inside & outside of the windows...is it possible it's on the inside of t... See more
What is a good adhesive to use on a wreath in a very hot location?
I have a front door that faces west and gets very hot in the summer. I made a wreath of twigs and sea shells.The hot glue melted, causing the shells to fall off. I tr... See more
What to hang over fireplace?
Right now I have a cream colored berry wreath over my fireplace. I will be getting the picture shown over my sofa ( that is a mock up so size won't be exact). Do you... See more
My purple clematis was supposed to be pink
I knew I wanted a clematis and I knew I didn't want it to be purple. So I went to Rural King and found me three pink Bee's Jubilee.