Concrete Resurfacing Removal
-
KMS Woodworks on Aug 16, 2012The leading cause of resurfacing problems is poor prep...where it is coming off are the trouble areas...you may have some luck re-working these and resurfacing the entire area. In the worst case you may need to have the whole area ground down.Helpful Reply
-
-
Mary P on Aug 16, 2012Thanks for the answers, but I'm still hoping for more ideas.Helpful Reply
-
-
Burco Surface & Decor LLC. on Aug 16, 2012is it just me or is there no picture to look at?Helpful Reply
-
-
Mary P on Aug 16, 2012It is not just you, I will try to do that tomorrow.Helpful Reply
-
-
Burco Surface & Decor LLC. on Aug 17, 2012ok, if you post a picture i may be able to help. I have played around with concrete once or twice. lolHelpful Reply
-
-
Mary P on Aug 21, 2012Thank you for the suggestions but this doesn't answer my question because I am hoping I don't have to resurface the area.Helpful Reply
-
-
KMS Woodworks on Aug 21, 2012If the material has lifted from the substrate it is only a matter of time before it cracks and brakes away. Any luck with the picHelpful Reply
-
-
Mary P on Aug 21, 2012This is the picture for the resurfacing mess with the concrete. How to get rid of it. Some of it was stuck right to the porch.Helpful Reply
-
-
KMS Woodworks on Aug 22, 2012ugh...that is a mess. One question you need to ask your self is how much time money and effort you want to put into this? Because of the color, your cheapest routed would be to paint the whole she bang...the texture would still be off but at least is would look better. In that case using a right angle grinder to ease the "edges" of where the surfacing broke away would reduce the chance of it getting worse and tripping etc. Your could resurface again which would be a lot of work. What might be the best option is installing some tile over the whole thing. A nice textured porcelain tile would be slip resistant and give a nice uniform look. That tile should be set with a polymer modified thin set...after the lose bits are grinder touched up.Helpful Reply
-
-
Mary P on Aug 22, 2012At this point, I have taken up all that has buckled underneath. We have tried sanding and scraping. I have to depend on others t do it for me. Maybe, I could just put a light layer of concrete over it and paint it.Helpful Reply
-
-
KMS Woodworks on Aug 23, 2012that may work but there seems to be a texture pattern there in the areas that have not failed. Matching that would be key to making it look uniform.Helpful Reply
-
Related Discussions
How to install a smart thermostat on my furnace?
Furnace is a Slant/Fin VSPH-90 boiler. There are three thermostat terminals at the boiler end, but only two have wires connected to them (see photo). The two wires co... See more
New concrete pour black stains?
We had a new 3500 sq foot concrete driveway poured starting 10 days ago. The first section poured has dark black spots that look like oil stains. Looks horrible, esp... See more
How to hide a pool filter?
Looking to hide this very hideous area. Thinking of a portable coat rack that you use when you have company. Bc it has wheels and can be moved easily.We still have to... See more
What could be causing a wet floor, if a plumber finds no leaks?
wet floor under sink dry iu and run water no leak? no smell all is clean. run water both tubs, garbage disposal, use sprayer everything underneath stays dry. Go away ... See more
How can I turn this old doll house into a book shelf?
What can I use to stop flies from collecting on my new deck?
My deck is new , I was told flies are attracted to the sap of the wood,.