I have a built-in microwave over w/trim kit which is already installed in the wall.
-
Imagery on Nov 05, 2011That's a tough one...Is there any way to slip a shim into the grill of the ventilation openings to allow for adjustment, instead of removing the screw? Some trim kits have slots that will allow minor adjustments to the microwave feet. If not, firm steady pressure directly to the screw head with the correct size screwdriver may work. Be sure to keep the screwdriver at the exact same angle as the screw, lots of pressure too, this should allow you to free it. Is the adjustment needed small enough that you may be able to lightly finesse the trim kit with a rubber mallet? May work if it only need a slight bump in the right direction. If not, drilling, or ez-out may be your only option. If you are still unsure, you may want to call a handyman to take a look for you....Good luck!Helpful Reply
-
-
KMS Woodworks on Nov 08, 2011How long has it been this way?...Is the microwave out of level or just the trim kit?...if it is the microwave and this was a recent install have the installer come back and fix it. A lot of the over head microwave I have installed "hang" from a cabinet of framing above...it may need shimming there. The the opening is out of square then the unit may be "racked" which means is a bit twisting in the vertical plane and the corners are no longer 90 degrees. this might be part of the problem with the door...if the door cap along the side opposite of the hinges is wedge shaped than this could be the problem.Helpful Reply
-
Related Discussions
Best way to make your driveway look like stone with paint?
Several years ago there was a DIY video on how to do this but can't fine it.
I am gluing some colored glass gems onto a glass window..
I am using E6000 to attach the glass gems to an old window. I want to make sure that everything will stay attached. I plan on spraying clear Krylon onto the whole gla... See more
How do I cover the edges of a cracked mirror?
I have a mirror tall and slender that has beveled edges and one side has chips out around the edging and I don’t know how or what to make a frame with to cover it. ... See more
How do you get rid of fruit flies from the soul of your plant?
There are fruit flies all over my plants.
How do I decoupage old glass bulb covers from light fixtures?
I need ideas for updating hanging light fixtures in kitchen then have the brass colors and clear glass cone bulb covers. I’d like to decoupage the glass covers ?