I have a built-in microwave over w/trim kit which is already installed in the wall.
-
Imagery on Nov 05, 2011That's a tough one...Is there any way to slip a shim into the grill of the ventilation openings to allow for adjustment, instead of removing the screw? Some trim kits have slots that will allow minor adjustments to the microwave feet. If not, firm steady pressure directly to the screw head with the correct size screwdriver may work. Be sure to keep the screwdriver at the exact same angle as the screw, lots of pressure too, this should allow you to free it. Is the adjustment needed small enough that you may be able to lightly finesse the trim kit with a rubber mallet? May work if it only need a slight bump in the right direction. If not, drilling, or ez-out may be your only option. If you are still unsure, you may want to call a handyman to take a look for you....Good luck!Helpful Reply
-
-
KMS Woodworks on Nov 08, 2011How long has it been this way?...Is the microwave out of level or just the trim kit?...if it is the microwave and this was a recent install have the installer come back and fix it. A lot of the over head microwave I have installed "hang" from a cabinet of framing above...it may need shimming there. The the opening is out of square then the unit may be "racked" which means is a bit twisting in the vertical plane and the corners are no longer 90 degrees. this might be part of the problem with the door...if the door cap along the side opposite of the hinges is wedge shaped than this could be the problem.Helpful Reply
-
Related Discussions
Cleaning mineral deposits off of glass
How do I remove mineral deposits from windows??? I've tried cleaning with vinegar on both the inside & outside of the windows...is it possible it's on the inside of t... See more
What to hang over fireplace?
Right now I have a cream colored berry wreath over my fireplace. I will be getting the picture shown over my sofa ( that is a mock up so size won't be exact). Do you... See more
Clean grout hard (iron) water stains?
We have a shower that has laminate side and flooring. The areas were grout is has turned orange/Black. I have used vinegar applied with toothbrush, Granite Gold grout... See more
Toilet: Rumbling / Vibrating Noise when FILLING up (SMOOTH when flush)
When flushing the toilet, no problem, smooth flush like all others, no issues. (My 1st inclination of the noise when filling up was a clogged toilet, but it flushes q... See more
How clean grout from a brick ?
hello all, I just moved to my new APT and I was working on my new kitchen. part of the work is to glue the bricks on the wall 1 centimeter apart so that the grout ... See more
I need a fabric stiffener that is weather resistant. Any ideas?
I created a fabric wreath and have tried two different brands of fabric stiffeners that have failed, any help appreciated.