I know that experts say that water heaters should be drained once a year to prolong their life span..
I like to do preventive maintenance whenever possible. What is the process? I envision connecting a water hose and seeing 40 gallons of water flow into my backyard and the yard of my neighbors. I do not want a flood!
-
3po3 on Dec 04, 2011That's about the extent of it. Your water heater manufacturer may have specific advice, but here is a nice general step-by-step guide with good photos etc. http://www.diynetwork.com/how-to/how-to-drain-a-water-heater/index.htmlHelpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 04, 2011The process is simple. You do not turn off the water to the heater and just drain it. This will not remove any real sediment doing it this way, Simply take a old short washer hose and a five gallon bucket. while the water is on to the heater using gloves so you do not scald yourself place hose in bucket, connect to hose bib on heater. Turn on bib and fill bucket until no more sediment comes out. Might only be one gallon, or may take several gallons. The reason why you keep the water on is it helps flush the bottom as it fills when draining. Once done turn off water drain and remove hose. If the hose bib continues to drip, and it often does. Do not over tighten it in an attempt to stop this drip. It will not work. Go to any hardware store and purchase a hose bib cap. Cost about $1.50 Put it one valve and your done. If the hot water heater was around 10 years old I would suggest against it at that time. As the heater ages the sediment builds up on the inside. It displaces any water that would normally be in contact with the bottom of the heater. These little dots of debris sometimes allows the heater to overheat those areas and for the lack of a better explanation burns holes into the bottom of the metal weakening it. When you flush after that has occurred. It is quite common to find leaks the next day. This happens a lot with older heaters when people move in to the home. They are in a cleaning mode using many more gallons of water then the heater may had seen for many years. All this additional water can flush the sediment around with the result of these little hot spots beginning to leak in short order.Helpful Reply
-
-
Alta M on Dec 05, 2011Thank you both very much!Helpful Reply
-
Related Discussions
Cleaning mineral deposits off of glass
How do I remove mineral deposits from windows??? I've tried cleaning with vinegar on both the inside & outside of the windows...is it possible it's on the inside of t... See more
What to hang over fireplace?
Right now I have a cream colored berry wreath over my fireplace. I will be getting the picture shown over my sofa ( that is a mock up so size won't be exact). Do you... See more
Clean grout hard (iron) water stains?
We have a shower that has laminate side and flooring. The areas were grout is has turned orange/Black. I have used vinegar applied with toothbrush, Granite Gold grout... See more
Toilet: Rumbling / Vibrating Noise when FILLING up (SMOOTH when flush)
When flushing the toilet, no problem, smooth flush like all others, no issues. (My 1st inclination of the noise when filling up was a clogged toilet, but it flushes q... See more
How clean grout from a brick ?
hello all, I just moved to my new APT and I was working on my new kitchen. part of the work is to glue the bricks on the wall 1 centimeter apart so that the grout ... See more
I need a fabric stiffener that is weather resistant. Any ideas?
I created a fabric wreath and have tried two different brands of fabric stiffeners that have failed, any help appreciated.