Painting Doors. I have several doors in which to paint. While I normally brush them and normally only need to do one or
-
Peace Painting Co., Inc. on Mar 03, 2012Sher-Wms Pro-Classic waterborne latex goes on top of oil with no priming. You only need to slightly dull the finish chemically or mechanically. And ofcourse they need to be free of dust or dirt. Chas.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Mar 03, 2012Thanks, I thought that as well, but not doing a lot of painting and hearing about issues with top coating over Oil paint I was concerned about peeling. So I am going to sand, then wipe with chemical dulling agent, clean and spray. Let you know how it works out. Thanks Chas,Helpful Reply
-
-
Dan's of Central Florida, Inc. on Mar 03, 2012Peace has you for the prep. Use a chemical deglosser on them and then lightly sand. Wipe it clean with mineral spirits and let them dry. If you have a lot of doors to spray, it is easiest if you take them all off the hinges and remove the knobs, etc. Take them to a place where you can set them all up for spray. Having the area protected from wind/debris will be best. Stand them straight up and use a piece of scrap wood to fasten them together at the top in a chain "W" formation. That should give you the clearance to spray each side.Helpful Reply
-
-
Peace Painting Co., Inc. on Mar 03, 2012Mineral spirits leaves an oily film. If you need a final wipe, Naptha works great because it evaporates cleanly.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Mar 03, 2012What about using lacquer thinner to clean dust? Little flammable, but not such a big deal. I have gallons of the stuff from painting cars over the years.Helpful Reply
-
-
Peace Painting Co., Inc. on Mar 04, 2012That'll work great, just not around a hot water heater (-; It's great you are staying busy.Helpful Reply
-
-
HandyANDY - Handyman & All Repairs, LLC on Mar 04, 2012Why don't you wipe them first with Goof-off and see if the "white" comes off...if it does, they aren't oil. Pro-Classic is a good paint for this. I'm not much for spray but with oil, you'll get a better finish...just watch for drips in the corners!Helpful Reply
-
-
Nichter's Home Services Corp on Mar 04, 2012TEST first so you know. Denatured alcohol will weaken or dissolve latex, but will not touch oil based except top clean it a bit. I just wet a paper towel well and lay it on the surface, and cover that with plastic so it does not evaporate. Overnight is all it takes. Latex will then lift right off or at least will wrinkle and pucker up.Helpful Reply
-
Related Discussions
How to make homemade ant poison?
I've been diving into the world of DIY solutions lately and stumbled upon homemade ant killers. I'm curious to know if any of you have tried making your own homemade ... See more
What could be causing a wet floor, if a plumber finds no leaks?
wet floor under sink dry iu and run water no leak? no smell all is clean. run water both tubs, garbage disposal, use sprayer everything underneath stays dry. Go away ... See more
How to keep critters from getting under a mobile home?
An animal got through the skirting on my mobile home and died. My place had a terrible odor for two months since I couldn't locate the intruder. Is there an easy way ... See more
What can I put on my wooden pool deck to minimize the hot surface?
What can I put on my wooden pool deck to minimize the hot surface. I do not want to use regular carpet as it holds water and my deck is hugh.
How can I protect my door-casing from my power wheelchair?
My doorways are being ruined by my power wheelchair. It's more than just scratches in the paint. I have deep gouges in the wood. Before I try to get these filled and ... See more
How do you get a suction cup bath mat to stick to the tub?
How do I decoupage old glass bulb covers from light fixtures?
I need ideas for updating hanging light fixtures in kitchen then have the brass colors and clear glass cone bulb covers. I’d like to decoupage the glass covers ?