What causes a pressure overflow valve on a gas hot water heater to intermittently drip.
-
HandyANDY - Handyman & All Repairs, LLC on Mar 29, 2012Spikes in water pressure from your local water supplier. Get a pressure gauge and screw it to a couple of outside spigots to get a reading. If it is continuing to leak it usually indicates that the pressure is too high. Also check your inside pressure reducing valve to see what it is set forHelpful Reply
-
-
KMS Woodworks on Mar 31, 2012Handy mentioned the basics...but these can also leak a bit if they have been "tripped". so the first trick is to get the cause corrected...then swap out the valve....do you know what you house pressure is?Helpful Reply
-
-
HandyANDY - Handyman & All Repairs, LLC on Apr 01, 2012Good point - I have noticed sometimes on the replacement release valves that they tend to stick open when tripped...not sure why. You may want to release the valve and see if it will resetHelpful Reply
-
-
Larry W on Apr 01, 2012I don't know what the house pressure is. All of my neighbors are on the same city system and none seem to have this problem. I can see their "outlet" pipes sticking out of their garage wall and they are not dripping. I will try releasing the valve to see if it may flush out a piece of grit. The dripping seems to be worse right after an extended use such as a shower or a dishwasher cycle.Helpful Reply
-
-
KMS Woodworks on Apr 01, 2012These items are not that pricey...about 12 to 15 bucks. If after a few attempts to get it working with out much luck I'd just swap it out...you might even be able to return you old one as "defective"...it could be a crappy spring in there.Helpful Reply
-
-
Larry W on Apr 01, 2012I'll try a couple of things later today or tomorrow. I'll post the results. Thanks for for interest.Helpful Reply
-
-
Terry S on Apr 01, 2012larry i thought i was the only one with that problem. it is aggravating. mine is worse if i turn the water heater up. doesnt seem to be as bad if the water heater is set low , but the higher i turn it the worse it gets ..nobody can figure it out. we even replaced the water heater thinking that was it.hope you get figured out.Helpful Reply
-
-
Plumber26 on Apr 02, 2012it's from thermal expansion.... you need to have a thermal expansion tank or thermal expansion valve installed @ your water heater to cure this problem..... you'll spend $100 on replacing your temperature/pressure relief valve until you finally realize "this isn't working". if not good at soldering, call a plumber... should't be a very expensive service call (100-150 bucks)Helpful Reply
-
-
Mr. Will. on Apr 03, 2012I've Replaced T&P Valve New that was bad from the Factory . It also can be to High Water pressure coming into the House. Get you a Water Pressure gauge about $13.00 which attaches to your outside Hose Bibb Front Yard which should be tied directly To your Water Service, before it goes thru a Pressure Reducing Valve to redure water pressure inside your hose. The pressure should read 55-65psi. Ihope this Info. help out Will B.Helpful Reply
-
Related Discussions
How does one stop a shower curtain from sucking in and attacking you
It is so aggravating. I recently moved into an apartment with no shower "doors". Every time I shower the shower curtain is sucked into the shower and will not lay dow... See more
GNATS - How to get rid of them?
Somehow my house and garden got tiny gnats that killed my fuchsia plant and fly everywhere. I have tried ALL the Web recommendations - soap and oil dishes, sand in th... See more
Can I decoupage my toilet seat what is needed to do this?
I rent but I hate the carpet in my master bedroom what can I do?
The carpet is stained and gross I have lived here for 6 years. Should I rip it out and change it without asking my landlord or can I suggest that I will pay for putti... See more
Can I hang a dresser mirror on my bedroom wall?
How to use a mirror from a old dresser can it be hung on a bedroom wall?
I'm trying to hang a curtain rod over a sliding glass door, but keep hitting something that I can't drill through.
The house is built of cement blocks, but there is drywall on the walls. I had another house that was the same type, but never had a problem with hanging curtain rods.... See more
Can I use my hot glue gun to stick crystals to mirrors?
I have a set of round frameless mirrors and I would like to create a pattern across them with crystals, I'm just not sure which glue is best, thank you.