what to do to prepare slice of tree for table project
-
John P on Apr 02, 2012seal the end grain with a good sealer and let the pc air dry or send it to be kiln dried down to about 7% moisture then it will be ready for planing and finishing also make sure it is stored flat and level and wieghing it down can help alsoHelpful Reply
-
-
KMS Woodworks on Apr 02, 2012End grain slabs tend to check or split more so than vertical "slabs" I would seal it up with some Anchor Seal...let it dry for a good long spell (normal air dry times are 1 year per inch of thickness) once dry some good sanding and a number of finish coats. end grain will absorb much more finish and it will take some time to get a "finish build" going. With a product like Minwax's wiping poly about 7-8 coats http://www.uccoatings.com/products/anchorseal2Helpful Reply
-
-
Elinor A on Apr 02, 2012Thank you for the suggestions but this doesn't answer my question because the entire piece is end grain this is a horizontal slice thru the main stem close to the bottom of the tree. and when you say seal what is considered a good sealer thanks for all your helpHelpful Reply
-
-
John P on Apr 02, 2012band it with a good wide ratchet strap and let it dry i would say approx 9 months to a year you want it to be under 8% moisture for best results then sand stain and seal it will take a few coats of sealer a good poly resin works well alsoHelpful Reply
-
-
KMS Woodworks on Apr 03, 2012Elinor...the Anchor Seal I Mention above has been the "industry" standard for sealing end grain on lumber for 30 years or so. When I purchase lumber for turning projects nearly every piece is sealed on all six sides with anchor seal. I have seen anchor seal for sale on ebay and amazon as well as many woodworking supply sites. John's idea above about a ratchet strap is a great idea...the log slice should be stored on its side so the seal ends are open to the air and not resting on some surface. I have worked with smaller sized "slices" for various projects. My girls call the really small 2" dia ones "tree cookies" The largest end grain round I have worked with was about 14". Bigger than that and it will not fit my lathe. Some of the longitudinal slabs I have worked with were 6 to 8 feet long and up to 2' wideHelpful Reply
-
Related Discussions
Why does my bathroom tub and sink sound like it's burping when I flush
This is new for us home, but built in 1959. Kitchen sink drains slow but have not heard burps.
Are gray walls here to stay or are they on their way out?
Hey everyone,Gray wall color has long been a favorite choice due to its versatility, modern appeal, and ability to complement a wide range of design styles.But the qu... See more
Quick, inexpensive fix to correct weathered,splintering wood on deck
My wooden deck is older, and the wood has started to darken and splinter. Outside of replacing the wood, is there anything I can do for a quick and inexpensive fix?
Looking for an idea to make the bookcase look flush against the wall.
It’s an Ikea Billy bookcase. The cut out for smaller baseboard doesnt work. Would like it to look flush with the wall. Would rather not have to cut the baseboard.... See more
How do I take off hard water from my tub?
Here’s my issue I have been living in the same apartment building for 18 years and I have a tub that deals with hard water on a daily basis. What is the best way fo... See more
How do I remove paint from painted tile and tub?
How should I remove paint from a tile floor and a bathtub?
What can I use to stop flies from collecting on my new deck?
My deck is new , I was told flies are attracted to the sap of the wood,.