Is peeling paint on house due to poor paint job or too much rain/water?
-
Clay B on Apr 02, 2012Could be many factors. Too many layers of paint, gets heavy, and can peel and fall off. Sometimes the wood needs to be sanded so primer and paint can stick. If wood was wet or contained too much moisture before you painted, that can cause peeling. Is water getting behind the wood? What type if siding do you have, shingles, clabboards etc? Was was on the surface before you painted, old paint, if yes, was the old paint sticking and not peeling? If you put oil based over latex, that would be problem. Latex over oil based is ok. SInce it's only where your garden is, it's probably getting way too much direct water, and the water is getting behind the wood siding.Helpful Reply
-
-
Peace Painting Co., Inc. on Apr 02, 2012Could this be the afternoon sun side too? A picture would be nice.Helpful Reply
-
-
Ginny C on Apr 02, 2012It is the the afternoon sun side. It's wood siding, not sure about the kind of paint but I think it was water based. The wood is so wet where it's been peeling that I can actually press into it with my fingers. If I get it to try out would I be able to do an inexpensive repair on it? The rest of the house is ok so it must be the amount of water over the past couple years. I'd like to be able to hold off an expensive repair until I can decide whether to put some other type of siding on the house.Helpful Reply
-
-
Peace Painting Co., Inc. on Apr 02, 2012Minwax makes a wood repair kit which is like bondo. You can also first brush on their wood hardener which is a wood fortifier or solidifier that bonds loose wood fibers together. Start by digging out the soft parts when dry, brush in the wood hardener then use the wood repair kit paste. Then caulk up the wood joints. This will give you one or two years of a patch until you decide. Best, CharlesHelpful Reply
-
-
Ginny C on Apr 02, 2012Thanks for the answers, but I'm still hoping for more ideas.Helpful Reply
-
-
Peace Painting Co., Inc. on Apr 03, 2012Ginny, the other loose paint areas need to be scraped and sanded until only firm paint remains. After washing and thoroughly dried, use oil base primer on the bare areas. Then you are ready to brush/roll apply two coats of top-line finish paint for the best protection. CPHelpful Reply
-
-
Ginny C on Apr 03, 2012thanks allHelpful Reply
-
-
Clay B on Apr 03, 2012If you can press your finger into the wood, you need to replace the siding in that area. Better to replace the siding before it rots the plywood/structure underneath that.Helpful Reply
-
-
Pam on Apr 20, 2012Did your painter use oil or latex base paint?Helpful Reply
-
-
Clay B on Apr 23, 2012One more thought, once siding is fixed, think about watering with a soaker hose.Helpful Reply
-
Related Discussions
How do I remove hard water deposits from stainless washing machine tub
My new home's washing machine appears to have a rough buildup near the top of the stainless tub. I have run Affresh through the unit but this remains. I don't want to... See more
How do we remove calcium deposits on our patio water fountain
How do we remove calcium deposits from our patio fountain and brick walkway?
Hardwood Floors or Carpet in Bedroom: What's Your Preference?
Hey Hometalkers! We've got a cozy debate going on here: when it comes to bedroom flooring, do you lean towards the warmth of carpet or the timeless elegance of hardwo... See more
How to remove rust from exterior door hinges without removing them?
If I remove my vynal shutters to paint can I reinstall them using the
Same nails/ screws holes won't be inlarged
How to remove paint from hinges
how to remove paint from hinges on cabinets doors still attached . want to paint kitchen but so much painted over hinges , screws won't budge.will i need to cut aroun... See more