During our stairwell remodel, I broke into the dead space under our stairs from inside the closet.
Can I remove the studs from the side & back of the closet? Are they just for attaching the wall board? OR are they part of the support system for the stringers? From what I've been reading, it seems that stairs are attached at the top & anchored at the bottom, with no need for support in between.
-
Nichter's Home Services Corp on Jul 29, 2011Your excellent photos show what you want to remove well enough, but not the stringers of the staircase itself - what would be left structurally if this kneewall is removed. But from the little I can see, I think this is only a partition and not support framingHelpful Reply
-
-
KL K on Jul 29, 2011@ Nichter: If you don't mind, please look at these photo too ... thx for your help. I was under the stairs in the "dead space: Working left to right; garage wall to interior wallHelpful Reply
-
-
JL Spring & Associates on Jul 29, 2011If you don't have to remove all the studding, leave as much as you can if it's just storage space. I'd certainly leave the center 2 Xs as step support ( you may pick up a squeek or 2 if they are gone) but the surrounding wall studs seem there to hold sheetrock, not the weight of the stairwell unit. Great pictures, thanks for bringing it to us here on HT! JLHelpful Reply
-
-
Nichter's Home Services Corp on Jul 30, 2011You'll be fine taking out that partition wall under the stairs here. /there is plenty of meat in the stringers and they were re-inforced with extra 2x4Helpful Reply
-
-
Paul M on Jul 30, 2011Unless your stairs are made out of steel I would never assume that you need no support in the center. Wood tends to move a lot more that steel, however if your stair was constructed in a structurally sound way it may be fine to remove that wall. If it is just part of the closet then why not leave one set of board in the center to be safe instead of sorry? I just recently removed a wall separating two rooms with a glue lam beam as the header of that wall and even though it has support in the wall I left a stud pack outside of the wall just to make sure. When it comes to structural elements it is better to be covered than to push the envelope and end up with a problem. Just my two cents for what it is worth. Nichter may be right but it is hard to know from any photo if there are any hidden issues. Just be careful.Helpful Reply
-
-
KL K on Jul 30, 2011Thank you all for the guidance ... sharing your expertise is greatly appreciated. Considering all the great advice: My plan is to remove the studs sitting between the stringers to allow full access to the space under the stairs. AND, I'll attached studs directly under the stringers to ensure support. Also going to "glue & screw" to see if we can take care of some of the squeaking while we're at it.Helpful Reply
-
-
Joe mitchell on Jul 30, 2011After removing the partition, I would add a 2x4 to the other side of the center stringer and screw the outer stringers to the studs. Do not screw or nail in the notched area of the stringers 90% of the time it splits. Glue would definitely be a good idea. The extra storage space will come in handy.Helpful Reply
-
-
KL K on Jul 30, 2011@ Joe: thank you so much for the tip re: notched area splittingHelpful Reply
-
Related Discussions
Can I decoupage my toilet seat what is needed to do this?
I rent but I hate the carpet in my master bedroom what can I do?
The carpet is stained and gross I have lived here for 6 years. Should I rip it out and change it without asking my landlord or can I suggest that I will pay for putti... See more
Can I hang a dresser mirror on my bedroom wall?
How to use a mirror from a old dresser can it be hung on a bedroom wall?
I'm trying to hang a curtain rod over a sliding glass door, but keep hitting something that I can't drill through.
The house is built of cement blocks, but there is drywall on the walls. I had another house that was the same type, but never had a problem with hanging curtain rods.... See more
Can I use my hot glue gun to stick crystals to mirrors?
I have a set of round frameless mirrors and I would like to create a pattern across them with crystals, I'm just not sure which glue is best, thank you.
How can I darken the color of painted furniture using varnish?
Hi, I just paint my outdoor dining set, but the color is a little lighter than what I want. I am planning to apply varnish on them and I was thinking to take advantag... See more
Can a water based varnish be used on chalk paint?
Is it possible to use a water based clear varnish instead of the finishing wax on chalk painted furniture? I love the look of distressed chalk paint but I'd like a sa... See more