494 Views
Garage Door Opener
by
Mark R
(IC: homeowner)
Replace Garage Door Opener.
Advice:
Sensors are the first thing to check and can be replaced easily for around $50. Do not replace circuit boards if bad. Buy a new unit for just a few dollars more!
Garage door would not go down. Checked out the safety sensors and they were fine. Turns out the circuit board failed. Better to just repolace with a new opener for a few more dollars vs a new board.
Materials:
Genie Powerlift Plus 1/2 HP Screw Drive Garage Door Opener - $0.00
Advice:
Sensors are the first thing to check and can be replaced easily for around $50. Do not replace circuit boards if bad. Buy a new unit for just a few dollars more!
Garage door would not go down. Checked out the safety sensors and they were fine. Turns out the circuit board failed. Better to just repolace with a new opener for a few more dollars vs a new board.
Materials:
Genie Powerlift Plus 1/2 HP Screw Drive Garage Door Opener - $0.00
Enjoyed the project?
Published September 2nd, 2010 2:17 PM
Comments
Join the conversation
2 comments
-
-
Yamini LEED AP at Urbanmotifs on Oct 19, 2010I need to reset the pin for my garage door..never done it before, Any suggestions?
-
Frequently asked questions
Have a question about this project?