How to make tile coasters with photos
by
Annie
I want to put photos of my nephews wedding on tiles to make coasters. The tiles are shiny do I need to sand them? Can I print the photos right onto regular paper and use modge podge to adhere them to the tile? and the most important question is what kind of sealant do I put on once it is finished and how many coats. I want to make sure that they can use these for years, and not have something happen if they put a hot drink or cold wet drink on them. Thanks Annie
3 answers
-
Modge podge normally won't be affected by water after it dries. Might want to test it before you commit the photos/tiles to the effect. Don't forget to put felt on the back!
Leah M
on Dec 03, 2014
-
Outdoor Modpodge (yes, there is such a thing) is the only one WATERPROOF after it dries. Regular MP is not. I would seal either one to be on the safe side. I just used a spray lacquer on a project, and it worked great. Also, if you print with an inkjet printer, the ink will likely smear. I usually just get laser prints made off. They are cheap, and do not smear!
9530106
on Dec 03, 2014
-
I have done this with pictures of dogs I cut from a calendar with some success. I believe where I failed was not top coating enough which I would do at least 3 times next time. Outdoor Modpodge sounds good.
Lori
on Dec 13, 2014
Sign Up to Answer
Related Discussions
Suggested Project Book
