Hey. Any advice on the best way to reattach the metal piece that fell off the rim of my antique wooden table?
-
Hudson Designs on Nov 06, 2011I would use a little Loctite PL PREM. adhesive caulk. You can find it at Lowes.Helpful Reply
-
-
KMS Woodworks on Nov 06, 2011I would use a 2 part epoxy...before mixing it up though be sure that the metal piece is the right shape...and has not gotten bent or kinked. You want the pieces to match each other perfectly. The glue I use the most is the 5 min epoxy from Devcon. mix up a small batch on a scrap of cardboard and apply a thin layer to the metal. Position the piece exactly where it need to be and secure with a few strips of painters tape pulled tight over the metal. clean up any glue squeeze out before it hardens... use just enough glue to minimize this. After a few hours you can remove the tape.Helpful Reply
-
-
Lulu Dubin on Nov 07, 2011Thanks guys I will definitely look into both of your suggestions and let you know how it goes.Helpful Reply
-
Related Discussions
How do I take off hard water from my tub?
Here’s my issue I have been living in the same apartment building for 18 years and I have a tub that deals with hard water on a daily basis. What is the best way fo... See more
How do I remove paint from painted tile and tub?
How should I remove paint from a tile floor and a bathtub?
What can I use to stop flies from collecting on my new deck?
My deck is new , I was told flies are attracted to the sap of the wood,.
What could be causing a wet floor, if a plumber finds no leaks?
wet floor under sink dry iu and run water no leak? no smell all is clean. run water both tubs, garbage disposal, use sprayer everything underneath stays dry. Go away ... See more
How to hide a pool filter?
Looking to hide this very hideous area. Thinking of a portable coat rack that you use when you have company. Bc it has wheels and can be moved easily.We still have to... See more
How to install a smart thermostat on my furnace?
Furnace is a Slant/Fin VSPH-90 boiler. There are three thermostat terminals at the boiler end, but only two have wires connected to them (see photo). The two wires co... See more