Day before Halloween = freak snow storm, no power for over a week.
-
Donna McCrummen on Dec 06, 2011Oops, mistake. The width of the opening is 33" the width of the fridge is 33.5" - we have 1 5/8 to play with - so we need to lose a half inch of the lip. Same question I guess. HmmHelpful Reply
-
-
KMS Woodworks on Dec 06, 2011Is this a laminate counter over a particle board core? If so I would rough out the cut with a circular saw then do some clean up work with a laminate trimmer. The back corner would need to be finessed with a recip saw once the circular saw butts ups at the backsplash. The very back corner could be cleaned up with a RO sander.Helpful Reply
-
-
3po3 on Dec 06, 2011I would pick a new fridge, but that's just me.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 07, 2011This can be done Donna, I would use a router with a guide to assure the cut goes smooth. A plane can work, but the edge can become uneven quite quick. The last few inches where the router cannot reach a good quality fine tooth trim saw can finish that part. Happy Holidays!Helpful Reply
-
-
Bernice H on Dec 07, 2011We had a series of "stuff" happen a few years ago, this brought back those memories! A few thousand dollars later, we finally breathed a sigh of relief. Thank goodness for Dave Ramsey and his advice of having emergency money saved. Hang in there, this too shall pass!Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011@Steve, I would take the easy route but this is the only stainless steel fridge that will even come close to fitting. They are so big these days. Thank you Woodbridge and KMS. I think I get what you're saying :-) just to be clear the opening for the fridge is boxed in vertically not up against a counter.Helpful Reply
-
-
Patricia M on Dec 07, 2011Oops, sorry to hit 'like'....I hope everything works out for you, Donna.Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011LOL thanks Patricia M. I'm sure I can do it - it's just a matter of using the right tools, etc.Helpful Reply
-
Related Discussions
How does one stop a shower curtain from sucking in and attacking you
It is so aggravating. I recently moved into an apartment with no shower "doors". Every time I shower the shower curtain is sucked into the shower and will not lay dow... See more
GNATS - How to get rid of them?
Somehow my house and garden got tiny gnats that killed my fuchsia plant and fly everywhere. I have tried ALL the Web recommendations - soap and oil dishes, sand in th... See more
Can I decoupage my toilet seat what is needed to do this?
I rent but I hate the carpet in my master bedroom what can I do?
The carpet is stained and gross I have lived here for 6 years. Should I rip it out and change it without asking my landlord or can I suggest that I will pay for putti... See more
Can I hang a dresser mirror on my bedroom wall?
How to use a mirror from a old dresser can it be hung on a bedroom wall?
I'm trying to hang a curtain rod over a sliding glass door, but keep hitting something that I can't drill through.
The house is built of cement blocks, but there is drywall on the walls. I had another house that was the same type, but never had a problem with hanging curtain rods.... See more
Can I use my hot glue gun to stick crystals to mirrors?
I have a set of round frameless mirrors and I would like to create a pattern across them with crystals, I'm just not sure which glue is best, thank you.