Day before Halloween = freak snow storm, no power for over a week.
-
Donna McCrummen on Dec 06, 2011Oops, mistake. The width of the opening is 33" the width of the fridge is 33.5" - we have 1 5/8 to play with - so we need to lose a half inch of the lip. Same question I guess. HmmHelpful Reply
-
-
KMS Woodworks on Dec 06, 2011Is this a laminate counter over a particle board core? If so I would rough out the cut with a circular saw then do some clean up work with a laminate trimmer. The back corner would need to be finessed with a recip saw once the circular saw butts ups at the backsplash. The very back corner could be cleaned up with a RO sander.Helpful Reply
-
-
3po3 on Dec 06, 2011I would pick a new fridge, but that's just me.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 07, 2011This can be done Donna, I would use a router with a guide to assure the cut goes smooth. A plane can work, but the edge can become uneven quite quick. The last few inches where the router cannot reach a good quality fine tooth trim saw can finish that part. Happy Holidays!Helpful Reply
-
-
Bernice H on Dec 07, 2011We had a series of "stuff" happen a few years ago, this brought back those memories! A few thousand dollars later, we finally breathed a sigh of relief. Thank goodness for Dave Ramsey and his advice of having emergency money saved. Hang in there, this too shall pass!Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011@Steve, I would take the easy route but this is the only stainless steel fridge that will even come close to fitting. They are so big these days. Thank you Woodbridge and KMS. I think I get what you're saying :-) just to be clear the opening for the fridge is boxed in vertically not up against a counter.Helpful Reply
-
-
Patricia M on Dec 07, 2011Oops, sorry to hit 'like'....I hope everything works out for you, Donna.Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011LOL thanks Patricia M. I'm sure I can do it - it's just a matter of using the right tools, etc.Helpful Reply
-
Related Discussions
Blackout curtains behind vertical blinds
I have two 6' patio doors, and I want to add blackout curtains to keep the sun/cold out. What is the best way to hang them, and what can I use to push the curtains ba... See more
What’s your favorite flower?
Let's brighten up our day with some floral beauty! Flowers come in so many shapes, sizes, and colors, and everyone has a favorite. We want to know: What is your favor... See more
Should I paint or stain my oak kitchen cabinets?
I was wondering if you could help me with something -- I have an entirely oak kitchen. I know it's the rage now to paint or gel stain cabinets. I've been considering ... See more
Any great tips for removing hard water stains from exterior windows?
Hey there fellow forum members!I need some help to make my home's exterior windows shine again! Any tips on tackling those stubborn hard water stains? They're driving... See more
Can I dry pine cones Outside instead of the oven?
they have been soaked in vinegar and water.
Can canvas outside window awnings be painted and how?
I have a dark green canvas awning and would like to change the color to gray. Is this possible and what type of paint do I use.
How can I make a DIY hair dryer diffuser?
Best hairdryer diffuser attachment!Protect your hair from heat and damage with Hairizone diffuser that Amazon reviewers swear by!