How ia the watering can/ with lights pouring out looking like water,
I've seen the project where they use a watering can and has lights pouring out looking like water. Need instructions
Related Discussions
How do I make shiny galvanized steel look dull like the watering can?
I am planning to use this galvanized bucket to store my hose & the watering can as a planter. Is there something I can do to the shiny upper part of the bucket to ma... See more
Blackout curtains behind vertical blinds
I have two 6' patio doors, and I want to add blackout curtains to keep the sun/cold out. What is the best way to hang them, and what can I use to push the curtains ba... See more
What’s your favorite flower?
Let's brighten up our day with some floral beauty! Flowers come in so many shapes, sizes, and colors, and everyone has a favorite. We want to know: What is your favor... See more
Should I paint or stain my oak kitchen cabinets?
I was wondering if you could help me with something -- I have an entirely oak kitchen. I know it's the rage now to paint or gel stain cabinets. I've been considering ... See more
Any great tips for removing hard water stains from exterior windows?
Hey there fellow forum members!I need some help to make my home's exterior windows shine again! Any tips on tackling those stubborn hard water stains? They're driving... See more
Can I dry pine cones Outside instead of the oven?
they have been soaked in vinegar and water.
Can canvas outside window awnings be painted and how?
I have a dark green canvas awning and would like to change the color to gray. Is this possible and what type of paint do I use.
Here's another one for you to look at: https://unskinnyboppy.com/2018/05/diy-fairy-lights-pouring-from-a-watering-can/
Hi Diane, here is a little video that may help
https://www.youtube.com/watch?v=xtO5Kl4b5-4
I actually make and sell these. I use solar fairy lights (the copper wire kind) and metal watering cans with a removable spray nozel. You have to make a few holes in the nozel bitter using a screw driver. I do the one in the middle and four or five evenly spaced a couple of rounds from the center. thread the entire length of lights through the spout starting inside the can. I measure out about 3-3 1/2 feet of lights and fold in half. I do this again for as many strands as I have enlarged holes. Then I fasten them together at the base, where the wire meets the plastic coated wire. Thread each looped section through the holes in the nozel, CAREFULLY, you don't want to break or cut a wire. Push all of the base into the nozel and screw back onto the spout. Hang by the handle. I hang mine on a shepherds hook and attach the solar pad to the hook with zip ties. Make sure the solar pad is on and let charge in the sun during the day. The results are quite pretty. Good luck.