I know that experts say that water heaters should be drained once a year to prolong their life span..
I like to do preventive maintenance whenever possible. What is the process? I envision connecting a water hose and seeing 40 gallons of water flow into my backyard and the yard of my neighbors. I do not want a flood!
-
3po3 on Dec 04, 2011That's about the extent of it. Your water heater manufacturer may have specific advice, but here is a nice general step-by-step guide with good photos etc. http://www.diynetwork.com/how-to/how-to-drain-a-water-heater/index.htmlHelpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 04, 2011The process is simple. You do not turn off the water to the heater and just drain it. This will not remove any real sediment doing it this way, Simply take a old short washer hose and a five gallon bucket. while the water is on to the heater using gloves so you do not scald yourself place hose in bucket, connect to hose bib on heater. Turn on bib and fill bucket until no more sediment comes out. Might only be one gallon, or may take several gallons. The reason why you keep the water on is it helps flush the bottom as it fills when draining. Once done turn off water drain and remove hose. If the hose bib continues to drip, and it often does. Do not over tighten it in an attempt to stop this drip. It will not work. Go to any hardware store and purchase a hose bib cap. Cost about $1.50 Put it one valve and your done. If the hot water heater was around 10 years old I would suggest against it at that time. As the heater ages the sediment builds up on the inside. It displaces any water that would normally be in contact with the bottom of the heater. These little dots of debris sometimes allows the heater to overheat those areas and for the lack of a better explanation burns holes into the bottom of the metal weakening it. When you flush after that has occurred. It is quite common to find leaks the next day. This happens a lot with older heaters when people move in to the home. They are in a cleaning mode using many more gallons of water then the heater may had seen for many years. All this additional water can flush the sediment around with the result of these little hot spots beginning to leak in short order.Helpful Reply
-
-
Alta M on Dec 05, 2011Thank you both very much!Helpful Reply
-
Related Discussions
How to use unused bathtub for storage
We do not use our bathtub, so I was wondering if anyone had any ideas on how to turn it into storage--shelves or something--without too much effort. Thanks
Can I use scented epsom salts for plants?
I've read to use empson salt in your plants, but my question is can I use scented Epsom salts?
How can I prevent my "full of yard waste" paper bags from the rain?
I don't have any place to store them once full, inbetween biweekly pick-ups. My yard is large, many bags, and not in a position to fully compost yet. Thanks!!!
Any advice for toning down a canvas painting?
I have a painting done on canvas that is a bit too bright. I would like to tone it down some. I was thinking of spreading on a light gray stain gel. Do you think t... See more
How to do MDF flooring in the Bathroom?
I want my bathroom flooring with MDF wood. Some of my friends suggested me this. Actually I have less idea on this. Even I don't know the basics difference between HD... See more
What could be causing a wet floor, if a plumber finds no leaks?
wet floor under sink dry iu and run water no leak? no smell all is clean. run water both tubs, garbage disposal, use sprayer everything underneath stays dry. Go away ... See more