What materials are needed to install an under floor radiant heating zone?
-
Yamini LEED AP at Urbanmotifs on Feb 18, 2012John, Please check out this bathroom renovation by KMS woodworks, this floor has a radiant heating and is good project for you to see and understand the materials involved for heated floors - http://www.hometalk.com/Kevin/project/2181Helpful Reply
-
-
3po3 on Feb 18, 2012You will also need to insulate under the radiant plumbing, and potentially reinforce the floor. Also, have somebody check the boiler to see if it needs to be altered or replaced for the needs of a radiant system.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Feb 19, 2012The concept of doing that is about right. Are you planning on doing this below the sub floor? or above then installing new tiles? There are differences in how you go about doing the pipes. Also your correct on changing the temps on the water. A mixing valve needs to be installed. Along with the controls that operate the zone. You need to purchase the correct PEX tubing for radiant heat, Not all plastic pipe is the same. As Steve said, you will need to install some sort of reflective insulation below the tubes to direct the heat upwards. There is a link to a suppler for the products that you may need to do the job. http://www.uponorpro.com/en/Products-and-Applications/Products/Heating-and-Cooling.aspx There is a lot of information needed to properly do this type of job. Heat loss will change how many pipes you will need, How hot the water will need to be plus a host of other issues. Its not as easy as you may think. Doing the job part is easy, Its the design process that can become complicated. And costly if done wrong.Helpful Reply
-
-
KMS Woodworks on Feb 19, 2012The electric version I did above works independent from the central system it that home...during the heating season "edges" spring and fall...it can be used to provide just a bit more heat in the smaller space with out have to heat of the whole zone or home.Helpful Reply
-
-
Speedheat Floor Heating on Feb 20, 2012Hi John, If you are doing a new floor covering installation, you may be interested in using electric radiant floor heating. This will cut down on your installation costs and time. Depending on which floor covering you are using, the installation is slightly different. However, with our systems, you would simply need the products that you would normally use for installing the floor covering, and we would supply the rest. For more information, please feel free to visit our website at http://www.speedheat.us. If you have any questions about our systems, please feel free to contact us. I know there are a few other options out there for electric radiant floor heating systems, as well, and you might want to look into them, too.Helpful Reply
-
-
John M on Feb 20, 2012I'm planning on installing 3/4" hardwood. The room has baseboard heat now and is a complete & separate zone. I have a fairly new boiler and lots of room to work. Just doing a cost trade off between radiant (hot water) and electric. Or maybe nothing keeping the baseboard. Seems like the radiant tubing can be expensive as I will need 5-6 hundred linear feet?Helpful Reply
-
-
Speedheat Floor Heating on Feb 20, 2012If you have a free minute and want to throw together a rough drawing with the dimensions and fax or email it to either 1-888-927-6357 or quotes@speedheat.us, we'll be happy to give you a free quote with layout and electrical requirements. This could help cut out some of the guesswork and all. :-)Helpful Reply
-
Related Discussions
Old desk with hard rubber top needs help
I have a very old desk that is in great condition except for the top. It is that old, hard rubber and it has a lot of dings and gashes (for lack of a better term). I ... See more
Do colors have to coordinate for bedroom and bathroom?
I recently got overzealous and bought a shower curtain, towels and rug for my bathroom in a totally different color than I planned on doing in the actual bedroom. Doe... See more
Should I remove plaster and lathe or can I just remove plaster?
I have an 1882 Balloon construction house that has some pretty extensive plaster falling off of the lath. I know that the lath actually adds to the wall stability, a... See more
How do I remove sand paint from the walls of a small bathroom?
Thought it was clever and a great look until I realized that if you fall against the wall it would scrape worse than a fall on cement. My husband is elderly and the l... See more
Has anyone had any luck removing artillery fungus?
Please provide personal success stories on how to get rid of fungus in mulch... not links because I have googled and watched others and tried. My daughter had a load ... See more
Which do you prefer: distressed wood or natural wood?
When it comes to choosing wood for your home decor, the finish can make all the difference in achieving the look and feel you want. Distressed wood, with its rugged c... See more
Repurpose glass crackle globes
I have several old solar lights with the glass crackle globe on top. The solar part doesn't work anymore. What could I do with the glass globes?