How do I install an overhead shower light?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How do i wire a bathroom fan and shower light??
Hi, i'm looking for some electrical advice. I have installed lots of lights anf switches, but i haven't added any new appliances or outlets to an existing room setup.... See more
How to restore an old cast iron wood burning stove?
The story of this stove started in a small town in Mexico. It was in my mother's family and was used to cook on and heat the kitchen when she was a kid. When the home... See more
There is a junction box there because it is against code to have electrical above the shower.
There are waterproof LED can lights. They look like a full can light, but they only recess a half inch or so. That's what I would recommend
We have 2 of those thin LED lights that are approved for damp places and they work great. Looking closely at your photo, it seems like they put a square peg in a round hole. I believe the fixtures approved for damp locations also have a seal to keep moisture out, which would help reduce air leakage. From memory, check Home Depot and expect to pay $30-35. Before you get too far, make sure that there is power in the box. If not, that may explain no light.
Buy a wet area appropriate fixture, turn off breaker, and twist and screw.
Baz9782607 is right, check for power first. You can pick up a little multitester for about15 bucks. Once you get that figured out, and once you get an appropriate fixture, shut off the power. Hook up the negative, the positive, and the ground. Easy peasy
Call an electrician!! If itās not done to code it can invalidate your home insurance. Itās not a DIY project. Just because there is a cover there doesnāt mean that proper ground fault wiring is installed.
I find it interesting that it's covered, possibly because it's not to code. I'd check your local electrical building codes before doing anything, then, call a licensed electrician. SAFETY first! Best of luck.
I have non-waterproof aluminum body in my hallway. Mine are only 2" diameter. Here's a photo. I found on Amazon. Check Home Depot, too. We love them and have them all over the place. I'll look for the link to ours. Probably later today.
Hi Brendan, here's the link I promised for my lights. Mine are DC 12v, but you can find different sizes and for 120v AC on Amazon, too. We prefer warm white 2700k-3000k when buying led lights.
Hope this helps!
https://www.amazon.com/acegoo-Recessed-Ceiling-Aluminum-Downlights/dp/B012KCNN5O