How to fix vinyl walls that will not lay flat by seams?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
Water damage on bathroom ceiling
I am about to patch up this water damage on a low bathroom ceiling. What can i paint/seal the entire ceiling with to minimize future water damage? the ceiling is very... See more
Brown paper floor/wall help
I have purchased a brown roll of paper because I wanted a consistent "vein" look through out the walls and the brown paper bags I was getting would sometimes be "vein... See more
Without a picture, hot hair dryer and then stack heavy books on them to cool.
I'm assuming the wall or studs behind it are flat and not bowed. The most probable cause is that the vinyl walls are slightly too wide and are flexing.
A photo and/or better description would be helpful.
You need to re glue them you could try to heat them up with a blow dryer or use a hot iron with a towel make shure you don’t burn plastic