How ia the watering can/ with lights pouring out looking like water,
I've seen the project where they use a watering can and has lights pouring out looking like water. Need instructions
Related Discussions
How do I make shiny galvanized steel look dull like the watering can?
I am planning to use this galvanized bucket to store my hose & the watering can as a planter. Is there something I can do to the shiny upper part of the bucket to ma... See more
How does one stop a shower curtain from sucking in and attacking you
It is so aggravating. I recently moved into an apartment with no shower "doors". Every time I shower the shower curtain is sucked into the shower and will not lay dow... See more
GNATS - How to get rid of them?
Somehow my house and garden got tiny gnats that killed my fuchsia plant and fly everywhere. I have tried ALL the Web recommendations - soap and oil dishes, sand in th... See more
Can I decoupage my toilet seat what is needed to do this?
I rent but I hate the carpet in my master bedroom what can I do?
The carpet is stained and gross I have lived here for 6 years. Should I rip it out and change it without asking my landlord or can I suggest that I will pay for putti... See more
Can I hang a dresser mirror on my bedroom wall?
How to use a mirror from a old dresser can it be hung on a bedroom wall?
I'm trying to hang a curtain rod over a sliding glass door, but keep hitting something that I can't drill through.
The house is built of cement blocks, but there is drywall on the walls. I had another house that was the same type, but never had a problem with hanging curtain rods.... See more
Here's another one for you to look at: https://unskinnyboppy.com/2018/05/diy-fairy-lights-pouring-from-a-watering-can/
Hi Diane, here is a little video that may help
https://www.youtube.com/watch?v=xtO5Kl4b5-4
I actually make and sell these. I use solar fairy lights (the copper wire kind) and metal watering cans with a removable spray nozel. You have to make a few holes in the nozel bitter using a screw driver. I do the one in the middle and four or five evenly spaced a couple of rounds from the center. thread the entire length of lights through the spout starting inside the can. I measure out about 3-3 1/2 feet of lights and fold in half. I do this again for as many strands as I have enlarged holes. Then I fasten them together at the base, where the wire meets the plastic coated wire. Thread each looped section through the holes in the nozel, CAREFULLY, you don't want to break or cut a wire. Push all of the base into the nozel and screw back onto the spout. Hang by the handle. I hang mine on a shepherds hook and attach the solar pad to the hook with zip ties. Make sure the solar pad is on and let charge in the sun during the day. The results are quite pretty. Good luck.