Day before Halloween = freak snow storm, no power for over a week.
-
Donna McCrummen on Dec 06, 2011Oops, mistake. The width of the opening is 33" the width of the fridge is 33.5" - we have 1 5/8 to play with - so we need to lose a half inch of the lip. Same question I guess. HmmHelpful Reply
-
-
KMS Woodworks on Dec 06, 2011Is this a laminate counter over a particle board core? If so I would rough out the cut with a circular saw then do some clean up work with a laminate trimmer. The back corner would need to be finessed with a recip saw once the circular saw butts ups at the backsplash. The very back corner could be cleaned up with a RO sander.Helpful Reply
-
-
3po3 on Dec 06, 2011I would pick a new fridge, but that's just me.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 07, 2011This can be done Donna, I would use a router with a guide to assure the cut goes smooth. A plane can work, but the edge can become uneven quite quick. The last few inches where the router cannot reach a good quality fine tooth trim saw can finish that part. Happy Holidays!Helpful Reply
-
-
Bernice H on Dec 07, 2011We had a series of "stuff" happen a few years ago, this brought back those memories! A few thousand dollars later, we finally breathed a sigh of relief. Thank goodness for Dave Ramsey and his advice of having emergency money saved. Hang in there, this too shall pass!Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011@Steve, I would take the easy route but this is the only stainless steel fridge that will even come close to fitting. They are so big these days. Thank you Woodbridge and KMS. I think I get what you're saying :-) just to be clear the opening for the fridge is boxed in vertically not up against a counter.Helpful Reply
-
-
Patricia M on Dec 07, 2011Oops, sorry to hit 'like'....I hope everything works out for you, Donna.Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011LOL thanks Patricia M. I'm sure I can do it - it's just a matter of using the right tools, etc.Helpful Reply
-
Related Discussions
What is a good adhesive to use on a wreath in a very hot location?
I have a front door that faces west and gets very hot in the summer. I made a wreath of twigs and sea shells.The hot glue melted, causing the shells to fall off. I tr... See more
What to hang over fireplace?
Right now I have a cream colored berry wreath over my fireplace. I will be getting the picture shown over my sofa ( that is a mock up so size won't be exact). Do you... See more
My purple clematis was supposed to be pink
I knew I wanted a clematis and I knew I didn't want it to be purple. So I went to Rural King and found me three pink Bee's Jubilee.
I need a fabric stiffener that is weather resistant. Any ideas?
I created a fabric wreath and have tried two different brands of fabric stiffeners that have failed, any help appreciated.
How to remove cigarette smoke smell from my sewing machine?
I just bought a used sewing machine. Brought it home and wiped it down with Clorox wipes and they were dirty. Now the machine reaks of cigarette smoke. I tried vinega... See more
How to take down painted popcorn ceiling in stairwell
suspect 2 layers of paint were used on popcorn ceiling in hallway and stairwell. One layer is somewhat grey-looks blotchy. Something less than a chisel that could hel... See more
What front door paint color would you avoid?
Let's have a little fun with front door colors! We all have our preferences when it comes to home decor, and that includes the color of our front door.But today, I wa... See more