Day before Halloween = freak snow storm, no power for over a week.
-
Donna McCrummen on Dec 06, 2011Oops, mistake. The width of the opening is 33" the width of the fridge is 33.5" - we have 1 5/8 to play with - so we need to lose a half inch of the lip. Same question I guess. HmmHelpful Reply
-
-
KMS Woodworks on Dec 06, 2011Is this a laminate counter over a particle board core? If so I would rough out the cut with a circular saw then do some clean up work with a laminate trimmer. The back corner would need to be finessed with a recip saw once the circular saw butts ups at the backsplash. The very back corner could be cleaned up with a RO sander.Helpful Reply
-
-
3po3 on Dec 06, 2011I would pick a new fridge, but that's just me.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 07, 2011This can be done Donna, I would use a router with a guide to assure the cut goes smooth. A plane can work, but the edge can become uneven quite quick. The last few inches where the router cannot reach a good quality fine tooth trim saw can finish that part. Happy Holidays!Helpful Reply
-
-
Bernice H on Dec 07, 2011We had a series of "stuff" happen a few years ago, this brought back those memories! A few thousand dollars later, we finally breathed a sigh of relief. Thank goodness for Dave Ramsey and his advice of having emergency money saved. Hang in there, this too shall pass!Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011@Steve, I would take the easy route but this is the only stainless steel fridge that will even come close to fitting. They are so big these days. Thank you Woodbridge and KMS. I think I get what you're saying :-) just to be clear the opening for the fridge is boxed in vertically not up against a counter.Helpful Reply
-
-
Patricia M on Dec 07, 2011Oops, sorry to hit 'like'....I hope everything works out for you, Donna.Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011LOL thanks Patricia M. I'm sure I can do it - it's just a matter of using the right tools, etc.Helpful Reply
-
Related Discussions
Getting rid of wild day lilies
Our yard is covered with wild (I assume, since we never planted them)day lilies which have taken over our yard. Short of blasting them with Roundup, is there anything... See more
How do I clean dull vinyl siding?
I've had my vinyl siding power washed, but it is still dull, like oxidized or something. Is there a cleaner I can use?
whats the cheapest and most efficient way to clean mildew from vinyl siding on a doublewide mobile home?on a budget
How to remove green mold and/or stains along vinyl siding of our house
Well, we did bad!!!! Having scrubs like hemlocks, and other flowering (forsythea) evergreen-like lower plans on the north face of our home has left green stains on si... See more
What can I do about north Florida lawn weeds in the fall?
What is the most effective way to deal with Florida lawn weeds during the fall season? Additionally, what recommendations do you have for the best year-round lawn car... See more
Can you put a bar of soap in a toilet tank?
I am always looking for a good cleaning hack and came across one where a lady put a bar of soap in the toilet tank. Before I try this out, I was wondering if it could... See more