Mold and Mildew in the Shower
-
SLS Construction & Building Solutions LLC on Apr 04, 2013You have got to control the moisture - you should be turning on the bathroom exhaust fan while you are taking your shower & letting it run 15 minutes afterwards. You can not leave bottles, scrubbies, or washcloths near grout joints. You may also wish to consider using a squeegee to get the water off the walls after you are done. As for the caulking, it needs to be removed completely, areas cleaned, and then reapplied (preferably with one meant for high water areas)Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Apr 04, 2013SLS Construction Solutions is spot on with their advice. Moisture is the primary reason for moldy areas. I would suggest that you should as stated either squeegee the walls and or dry them with the bath towel once your done using it. Keeping these areas dry is the cure. If the grout is also becoming a bit moldy, you should consider after doing a thorough scrubbing re-seal it with grout sealer. Many times then not the grout becomes porous over time and begins to hold soap and soils, all that add up to future mold development. They make these auto sprayers that are hung on the shower head and spray once activated by a button a drying and cleaning chemical that is suppose to help prevent this build up as well. I have not personally used them, but have heard good things about them from those who use them. Sort of works like the drying agent you use in your dishwasher to prevent spots.Helpful Reply
-
-
Linda D on Apr 04, 2013thank you all so much for the suggestions. The caulk I use is not grout though, Does that make a difference? I use a caulk gun with the solution for tub and shower and it only needs caulking around the top of the tub where the wall meets. I do have a squeegee and will use that in future. Thanks again, LindaHelpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Apr 04, 2013caulk for corners between tub and wall. grout everywhere else.Helpful Reply
-
-
Andrea S on Apr 05, 2013Squeegee the walls after you are done showering. There is a cleaner called Scrub free that I use between showers. Apparently it works. Before the scrub free I scrubbed with bleach and an old tooth brush. I also use a cloth by the sink for after we are done washing hands or brushing teeth, we wipe down the water around the sink and the edge of the sink. So we don't leave water on the counter to evaporate. The kids are learning too how to keep the bathroom dry. The caulk is not meant to be there forever. Eventually they all get mould and need replacing. I have read that with proper installation it could last 20 years, but I also found a recommendation to replace it yearly to prevent mould from forming on the surfaces under the caulk.Helpful Reply
-
-
SLS Construction & Building Solutions LLC on Apr 05, 2013Thank you & spot on to @Woodbridge Environmental Tiptophouse.com for catching the grout part, I missed that . @Andrea S - as for the caulk you should inspect it yearly (I recommend twice - Jan & July inside - spring & fall for exterior) but just replacing it willy nilly is a waste & can cause more issues if you damage areas. A good caulk or sealant can last for many years easily.Helpful Reply
- See 1 previous
-
-
Designs by BSB on Apr 05, 2013advice spot on thus far... to help you be more accountable? consider spending $15 and install a timer so the exhaust fan stays .. after you leave, and you dont have to worry about shutting it off! Home Depot has one.. http://thd.co/17ieFtZ If these do not do the trick? may need to consider doing the math to find out if your fan is sized right for your bathroom. Knowing what the CFM (Cubic Feet per Minute) rating is key. This site has a quick calculator to help you: http://www.ventingdirect.com/bath-exhaust-fan-calculator/c16459Helpful Reply
-
-
Linda D on Apr 05, 2013I love Home Depot. They have everything including Do It Herself Classes.Helpful Reply
-
-
Andrea S on Apr 08, 2013Thanks I will do that. We didn't check it, we didn't know either how often we had to do it and learned from the mistake. We were told to just run the fan for a half hour after showers. But since we replaced it we check it and also use a squeegee and the fan and try to wipe dry where we can.Helpful Reply
-
-
Capernius on Feb 11, 2016after your shower or bath, wipe it down with a towel & then spray it with vinegar...do NOT wipe the vinegar, leave it sit. The acid in the vinegar will kill the mold & mildew & if you do this on a regular basis, you will never have mold or mildew again.Helpful Reply
-
Related Discussions
How to clean a mirror without streaks?
Every time I clean my mirrors, they end up having tons of streaks and almost look worse than before I started. What could I use to clean them that won't leave streaks... See more
How to clean burns on stainless steel pans?
Help! I burned my pan. How do I clean stainless steel cookware that's been burned?
How to clean shower doors
How to clean glass shower doors
How to clean hardwood floors in the kitchen?
What is the best way to clean hardwood floors in the kitchen?
How to clean my kitchen cabinets from grease?
My kitchen cabinets are embarrassingly greasy. Please share your degreasing tips with me so I don't have to cringe every time I glance at my cabinets.
What is the best way to clean mold & mildew in the bottom of a shower?
I have tried everything! Thank you!
Green mold inside one glass block in shower, how to remove mold?
I need to know if there is a simple way to remove without taking out glass block?