I am trying to replace a light ballast. They both have red wires coming out of thr right.
-
3po3 on Jan 14, 2012Can you take a picture of this setup? And I'm not absolutely certain what your question is.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Jan 15, 2012The wiring of this type of lamp must match the wiring diagram that is on the face of the new ballast. If it does not have one which most of them do, then you need to check with the manufacture of this product for the wiring diagram for this replacement unit. You must be sure that this is the correct ballast for the lamp size and type your using. Some have auto starts, some require a starter. What ever you purchased must match exactly what you currently have or you risk an explosion of the new ballast being put in. Here is a link that you can perhaps refer to. About mid way is wiring diagram. http://donklipstein.com/f-lamp.htmlHelpful Reply
-
-
LandlightS on Jan 15, 2012You have an electronic ballast that is replacing the old magnetic ballas (which are hard to find today thanks to Gov't regulations). It will work fine but you have to rewire the fixture to match the wiring diagram on the ballasts. Also check to lamp description: is this ballast for a T12 lamp or a T8 lamp (or both). If you decide not to attempt to rewire the fixture, either have an electrician install the ballast or return it and purchase a new fixture with an electronic ballast for just a few dollars more.Helpful Reply
-
-
LandlightS on Jan 15, 2012PS: hate to say it but the link from Woodbridge is outdated. It states that a 4 light fixture will have two ballasts and if you go to HD, Lowes or any Ace Hardware you will find a 4 lamp electronic ballasts that replaces the 2 old magnetic ballasts.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Jan 15, 2012Thanks Landlights, I will update my library accordingly. I would think however regardless of type etc. Does not the ballast have the wiring diagram on the face of it? That should answer his question I would think?Helpful Reply
-
-
LandlightS on Jan 15, 2012Yes, th ballast does have a wiring diagram, however they are always not that easy for a DIYer to understand. With the electronic ballast, the neutral no longer goes to the lamp holder, but to the ballast, and that is where it get confusing. If he were replacing a " rapid start" ballast, he would find the neutral connected to the ballasts.Helpful Reply
-
-
Don H on Jan 15, 2012Thanks Woodbridge and Landlights-Diagram helped , and not needing a neutral wire to the lamp holder.Helpful Reply
-
Related Discussions
Getting rid of wild day lilies
Our yard is covered with wild (I assume, since we never planted them)day lilies which have taken over our yard. Short of blasting them with Roundup, is there anything... See more
How do I clean dull vinyl siding?
I've had my vinyl siding power washed, but it is still dull, like oxidized or something. Is there a cleaner I can use?
whats the cheapest and most efficient way to clean mildew from vinyl siding on a doublewide mobile home?on a budget
How to remove green mold and/or stains along vinyl siding of our house
Well, we did bad!!!! Having scrubs like hemlocks, and other flowering (forsythea) evergreen-like lower plans on the north face of our home has left green stains on si... See more
What can I do about north Florida lawn weeds in the fall?
What is the most effective way to deal with Florida lawn weeds during the fall season? Additionally, what recommendations do you have for the best year-round lawn car... See more
Can you put a bar of soap in a toilet tank?
I am always looking for a good cleaning hack and came across one where a lady put a bar of soap in the toilet tank. Before I try this out, I was wondering if it could... See more