I redid my tub, with tub paint, now the paint is peeling, any suggests
-
Walden Enterprises on Jul 01, 2013Lisa - even though you may have followed all the directions on the can, it sounds like the problem is adhesion at those spots. If you used the product from a home improvement store that comes in a kit (with a cleaning solution, steel wool, gloves, etc.), you could try just doing the whole process again, being extra diligent where it is peeling. I will tell you that there will be some texture difference where the peeling stops. This tub paint just does not have the "build up" that other paint has. If it really begins to peel, just go for it and remove as much as wants to even think about coming off and then prime with a product called XIM, available at Sherwin Williams. It is a super strong oil-based primer that will bond and seal the surface. Then, re-apply the tub paint and you should be good! Still cheaper than a pro! Good luck. Oh, and be sure and ventilate your work area properly - this is VERY stinky stuff and can be dangerous. No open flame near the work area!Helpful Reply
-
-
KMS Woodworks on Jul 01, 2013Most paint failures have to do with improper of insufficient prep. If you were working from the "can" I would think the latter. A little residual moisture or a bit of soap scum is all it takes to pose problems. You may have some luck reworking those areas taking extra time in the prep.Helpful Reply
-
Related Discussions
My cabinets are peeling. Is there any kind of paint I can use in them?
How do I strip off the covering before I paint? I would like to paint either white or light gray. Can this even be done?
How do I prevent my dogs bed from sliding in her kennel?
When my dog moves around her bed moves with, thus creating a loud dog nail against plastic noise
Hi. What is the South African equivilent of Dawn soap?
How can I update my old stair case?
How can I update my stair case
GNATS - How to get rid of them?
Somehow my house and garden got tiny gnats that killed my fuchsia plant and fly everywhere. I have tried ALL the Web recommendations - soap and oil dishes, sand in th... See more
How to install a smart thermostat on my furnace?
Furnace is a Slant/Fin VSPH-90 boiler. There are three thermostat terminals at the boiler end, but only two have wires connected to them (see photo). The two wires co... See more