I would like to make a concrete ramp from my garage floor to my laundry room entrance. I would appreciate any ideas.
-
3po3 on May 23, 2012Do you have a photo of the space? For convenient use, don't do a greater slope than 2 inches per foot, assuming you have the room.Helpful Reply
-
-
KMS Woodworks on May 24, 2012If this is for ADA access then you need to stay within set parameters for slope, width, hand rails etc? is this the case?Helpful Reply
-
-
Chuck B on May 24, 2012It's not an ada issue, just a getting shopping cart over the door threshold at home. I built a wooden proto type that works, but something more permanent would be good.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on May 24, 2012You simply need to construct or cut two boards at the angle of the ramp you desire. Fasten them down with a little amount of epoxy to keep them from moving then using mortar mix or sand mix not concrete mix pour some and level with a board across the two fastened boards. Make the mix real thick like cookie batter so it does not slump down. Trowel smooth. As it begins to set, take a small floor broom and lightly brush from side to side to create a textured finish so you do not slip. They make edge trowels to round over the cement where it comes into contact with the boards to give it a smooth finish. Once dry simply using a flat pry bar pop off the two form boards on each side to complete the project. The reason why not concrete mix is that it contains stones that will not allow you to feather the edge of the cement to the floor.Helpful Reply
-
-
Chuck B on May 25, 2012Thanks for the concise response. This answered my question completely. I will try and get it done soon and send a picture.Helpful Reply
-
Related Discussions
How do I get grass out of a phlox bed?
This flower bed is extremely dense with phlox. Last year, I pulled much of the grass out by the roots, but it came back with a vengence this year. We've had a ton of ... See more
Has anyone used a shower liner for curtain backing/liner?
I'm making new curtains in several rooms using cotton calico fabric. I'm trying to find an inexpensive -as possible lol- way to give a little more weight to them and ... See more
How can I remove a magnetic door knocker from a metal door?
The magnet in the knocker has "welded" to the door and seems impossible to remove. I have to paint the door so if the paint is damaged its not a problem.
How to remove rust from exterior door hinges without removing them?
GNATS - How to get rid of them?
Somehow my house and garden got tiny gnats that killed my fuchsia plant and fly everywhere. I have tried ALL the Web recommendations - soap and oil dishes, sand in th... See more
How do I remove hard water deposits from stainless washing machine tub
My new home's washing machine appears to have a rough buildup near the top of the stainless tub. I have run Affresh through the unit but this remains. I don't want to... See more
How do we remove calcium deposits on our patio water fountain
How do we remove calcium deposits from our patio fountain and brick walkway?