Replace a small metal roof, is it a DYI project?
-
Woodbridge Environmental Tiptophouse.com on Jun 16, 2012It can be. Depends upon how steep the roof is and your ability to climb. It does take a few special tools however to tighten up the standing seams and a few ladders to place on the roof. As you do not want to stand directly on the roof or it will bend. This results in poor seaming and possible future leaks.Helpful Reply
-
-
KMS Woodworks on Jun 16, 2012house...shed...what type of structure is this. Metal roofing can take on many forms...some are much more friendly to install. check out this article I wrote http://www.networx.com/article/is-panel-roofing-for-youHelpful Reply
-
Related Discussions
How to make homemade ant poison?
I've been diving into the world of DIY solutions lately and stumbled upon homemade ant killers. I'm curious to know if any of you have tried making your own homemade ... See more
What could be causing a wet floor, if a plumber finds no leaks?
wet floor under sink dry iu and run water no leak? no smell all is clean. run water both tubs, garbage disposal, use sprayer everything underneath stays dry. Go away ... See more
How to keep critters from getting under a mobile home?
An animal got through the skirting on my mobile home and died. My place had a terrible odor for two months since I couldn't locate the intruder. Is there an easy way ... See more
What can I put on my wooden pool deck to minimize the hot surface?
What can I put on my wooden pool deck to minimize the hot surface. I do not want to use regular carpet as it holds water and my deck is hugh.
How can I protect my door-casing from my power wheelchair?
My doorways are being ruined by my power wheelchair. It's more than just scratches in the paint. I have deep gouges in the wood. Before I try to get these filled and ... See more
How do you get a suction cup bath mat to stick to the tub?
How do I decoupage old glass bulb covers from light fixtures?
I need ideas for updating hanging light fixtures in kitchen then have the brass colors and clear glass cone bulb covers. I’d like to decoupage the glass covers ?