Leak in the tile around the bottom of the shower.
-
Woodbridge Environmental Tiptophouse.com on Jun 17, 2012If the water has been leaking for more then a few days, you have mold there. It takes around 48 hours for mold to begin to develop. The question is was the leak stopped? If so, and the tiles are secure and there is no stains coming through the wall, then the amount of mold present most likely is not enough to raise any real concern. However if you do see stains that has resulted from the leaks, or the area is prone to moisture then you need to open the walls and remove even the slightest amount of mold that has developed or it will continue to grow until it becomes a real health hazard. There are Boroscopes that are little cameras on the end of a flexible tube that can be inserted in a small hole to look and see if mold has begun. There are also tests using a wall check system that draws air out from behind the wall surface and impacts any mold spores that may be present where you cannot see them. But those methods are better left to your local mold testing company.Helpful Reply
-
Related Discussions
My shower is leaking. Do I call a plumber or tile person?
How do I tile around a one piece fiberglass tub/shower surround?
How do I tile around my tub and shower when the corners are not square
Toilet: Rumbling / Vibrating Noise when FILLING up (SMOOTH when flush)
When flushing the toilet, no problem, smooth flush like all others, no issues. (My 1st inclination of the noise when filling up was a clogged toilet, but it flushes q... See more
Clean grout hard (iron) water stains?
We have a shower that has laminate side and flooring. The areas were grout is has turned orange/Black. I have used vinegar applied with toothbrush, Granite Gold grout... See more
How clean grout from a brick ?
hello all, I just moved to my new APT and I was working on my new kitchen. part of the work is to glue the bricks on the wall 1 centimeter apart so that the grout ... See more
I need a fabric stiffener that is weather resistant. Any ideas?
I created a fabric wreath and have tried two different brands of fabric stiffeners that have failed, any help appreciated.