What is the code distance between wall studs in a house?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
What's the best way to find a stud through an old house wall?
We have an old house that still has lathe and plaster walls with drywall over top. We are having a terrible time trying to find the wall studs. We have tried a good q... See more
Water damage on bathroom ceiling
I am about to patch up this water damage on a low bathroom ceiling. What can i paint/seal the entire ceiling with to minimize future water damage? the ceiling is very... See more
Spacing between studs needs to be an exact measurement so that 4-foot-by-8-foot sheets of drywall or exterior sheathing can be evenly distributed across the center of each stud to complete the wall assembly.
Sixteen-Inch on Center
Sixteen-inch on center means there are exactly 16 inches from the center of the narrow (nominal 2-inch) side of one stud to the center of the next stud. Standard two-by-four studs actually measure about 1 1/2 inches by 3 1/2 inches. Studs are installed in vertical rows between the walls top and bottom plates. The studs are placed 16 inches on center for most interior load-bearing walls and non-load-bearing walls as well as exterior load-bearing walls. Each stud is nailed in place with the 1 1/2-inch edges parallel to the faces of the wall.
It's not uncommon in older homes to find interior walls with studs set 24 inches on center, or even 12 inches on center or anywhere in between. Spacing was not as crucial in older homes because the walls were often covered in lath and plaster, so the framing didn't have to conform to a 4-by-8-foot panel. Today, stud placement also is strictly governed by building codes, based on what the walls are supporting.
William is right about his advice on both the new construction and I can tell you from experience older homes are pretty much all over the place.
16" on center
sixteen inches on center
Sometimes that depends by state so I suggest you ask your state codes inspector. Here in NY I believe it is 16".
it is usually 16 inches from center to center of studs, but there are a few exceptions
William explains it perfectly. I know it's 16" on center, but he explains why. I'd print his explanation and keep it on file.
16 inches on center
Thank you all so much!!